ALLPOWER SupaSwift 635 LITTLE BOB Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Cortacésped ALLPOWER SupaSwift 635 LITTLE BOB. ALLPOWER SupaSwift 635 LITTLE BOB 10 páginas. 18”, 21”
Imprimir páginaWARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Cleaning unit after each use will help prevent fire hazard from dry grass and extend the working
life of the machine. Protect the cutting components against corrosion by applying any good
quality, commercial lubricant such as WD-40 spray lubricant.
Wipe down the engine and outside of the machine with a damp cloth.
Keep blades in good condition. Replace if cutting performance deteriorates over time.
Replace blades and bolts as a full set only. This prevents vibration problems.
Replace blade disc if blade mount holes are worn or cracking is evident.
Warning: Never operate this machine if the blades or blade disc are loose or damaged.
Always inspect wheel bearings for looseness or damage prior to each use replace when worn.
Always inspect machine for any loose, worn or broken components before starting the engine.
Replace engine oil at intervals as specified in the engine manual.
For aspects of servicing not covered by this Operators' Manual, refer to an authorised Allpower Service
Centre.
DANGER: Shut engine down, ensure all
rotating parts have stopped and remove
spark plug lead before commencing
maintenance work.
The blades in this Supaswift Lawn Mower are designed to cut
grass. Drier than normal conditions and foreign objects can
cause more wear. In time, these blades will wear and will
need to be replaced in order to obtain maintain a clean cut on your grass. To replace blades,
follow the procedure set out below:
1.
Ensure that the engine is turned off and that all moving parts have come to a complete stop.
2.
Remove the spark plug lead from the spark plug.
3.
Set height adjuster to position 6-12 (Refer Page 7).
4.
Lower handles toward the ground and place heavy object on handles (refer Image 3).
5.
Remove blade disc or blade by loosening centre-mounting bolts.
6.
Remove blades from disc by loosening mount bolts.
7.
Assembly is reversal of this procedure.
SERVICING INFORMATION
Replacement of Blades
CAUTION: DO NOT touch parts
which are hot from operation.
ALWAYS allow parts to cool.
WARNING: If you are not confident in carrying
out the following maintenance, or have diffi-
culty understanding the instructions, consult an
authorised Servicing Dealer
C AUTION : Blades ar e
sha r p and can cut you. Always
wear gloves, and use extra ca u tion
when servicing them
P a g e
| 8