Allpro APS2730H Instrucciones de reparación y lista de piezas - Página 6
Navegue en línea o descargue pdf Instrucciones de reparación y lista de piezas para Lavadora a presión Allpro APS2730H. Allpro APS2730H 16 páginas.
Imprimir páginaRelieve pressure, page 4.
Problem
Engine will not start or
No gasoline in fuel tank or carburetor
is hard to start.
Low oil
Start/Stop switch in STOP position
Water in fuel or old fuel
Engine flooded or improperly choked
Dirty air cleaner filter
Spark plug dirty, wrong gap, or wrong
type
Gun not triggered
6.5 hp Briggs & Stratton model may
experience "vapor lock" due to gas type
and temperature
Engine misses or
Partially plugged air cleaner filter
lacks power
l
k
Valve adjustment (lash) worn
Spark plug dirty, wrong gap, or wrong
type
Pressure is too low
Worn or wrong size tip
and/or pump runs
d/
Inlet filter clogged
roughly
roughly
Worn packings, abrasives in water, or
natural wear
Inadequate water supply
Fouled or dirty inlet or discharge valves
Restricted inlet
Worn inlet or discharge valves
Leaking high–pressure hose
Water leaks from
Worn packings
under pump minifold
Water on oil side of
Humid air condensing inside crankcase
pump
p
p
Worn packings
Oil seals leaking
6
309887
Troubleshooting
Cause
Solution
Fill tank with gasoline, open fuel shutoff valve.
Check fuel line and carburetor.
Add oil to proper level.
Move switch to START position
Drain fuel tank and carburetor. Use new fuel
and make sure spark plug is dry.
Open choke, pull engine starter rope several
times to clear out fuel. Make sure spark plug
is dry.
Remove and clean.
Clean, adjust gap or replace.
Trigger gun while starting engine.
Allow unit to cool approximately 15 minutes
and restart.
Remove and clean.
Adjust valve lash to manufacturer's
specification.
Clean, adjust gap or replace.
Replace with tip of proper size.
Clean. Check more frequently.
Check filter. Replace packing.
Check water flow rate to pump.
Clean inlet and discharge valve assemblies.
Check filter.
Garden hose might be collapsed or kinked.
Replace worn valves.
Replace high–pressure hose.
Install new packings.
Change oil as specified in Maintenance Chart
(page 5).
Install new packings.
Install new oil seals.