DiamaPro Systems DP-JSX-10 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Sierra DiamaPro Systems DP-JSX-10. DiamaPro Systems DP-JSX-10 8 páginas. Walk-behind saw

Set-Up:

Red Arrows (Fig. 1)

1. Install the control and lift handle as shown in Fig. 1.

2. Hang cord on handle cord rest. Secure on rest using

the factory provided twist tie.

3. Apply powerhead trigger lock. Plug cord into the

electrical box.

Never leave the unit plugged in while unattended or while

replacing the blade

Blade Installation:

Green Arrows (Fig. 2)

1. Unplug the power cord from the electrical box.

Remove the blade guard.

2. Remove outer blade clamp and install the blade.

3. Firmly tighten the blade.

We recommend using a DiamaPro Systems® 8" Diamond Blade

Blade Pointer Alignment:

1. After proper blade installation, align the rear pointer

and the blade with a known straight edge.

2. Using the supplied washer/shims, align the front

pointer to the known straight edge. Be sure to tighten

the front pointer bolt.

Feature Call Outs:

Yellow Arrows (Fig. 3)

2-inch dust port: Minimum 250 CFM required

Blade depth adjustment knob. Loosen knob and slide

left or right to set blade depth.

Foot lever locks the motor in the UP position. Be sure

to install the lock-out pin while not in use and for

transportation.

Call 470-977-2323 or visit our website www.diamaprosystems.com for our terms and conditions

PRODUCT SET-UP

Blue Arrows (Fig. 2)