Miller 043688 Manual del usuario
Navegue en línea o descargue pdf Manual del usuario para Sistema de soldadura Miller 043688. Miller 043688 4 páginas.
Imprimir página
OWNER'S MANUAL
RCCS-5 (043718), RCCS-14 (043688), RCCS-6M (13Ft. 3in.) (195184),
And RCCS-6M (26Ft. 6in.) (195503)
DANGER! − Indicates a hazardous situation which, if not
avoided, will result in death or serious injury. The possible
hazards are shown in the adjoining symbols or explained
in the text.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury. The possible ha-
zards are shown in the adjoining symbols or explained in
the text.
NOTICE Indicates statements not related to personal injury.
Indicates special instructions.
CALIFORNIA PROPOSITION 65 WARNINGS
Welding or cutting equipment produces fumes or gases which contain chemicals known to the State of California to cause birth defects and, in
some cases, cancer. (California Health & Safety Code Section 25249.5 et seq.)
This product contains chemicals, including lead, known to the state of California to cause cancer, birth defects, or other reproductive harm.
Wash hands after use.
SECTION 1 − INSTALLATION AND OPERATION
.
The RCC (Rotary Current And Contactor Control) is equipped with a 14-pin, 5-pin, or a 6−pin plug for connection to the welding power source.
Contact your local distributor for correct adapter if plug does not mate with receptacle on welding power source.
Increase
1
Fsafe1 2013-10
Fsafe3 2013-10
4
3
Decrease
2
Figure 1-1. Installing And Operating An RCC Control
OM-2806
2017−02
Beware of electric shock from wiring. Disconnect input
power before installing this kit. Reinstall all panels and
covers.
Wear safety glasses with side shields.
5
!
Be sure remote control is turned
all the way off before turning on
or off the welding power source.
1
Torch
2
Hook And Loop Straps
3
Current And Contactor Control
Actuator
Begin turning actuator in the Increase
direction as shown to close contactor,
and energize the welding power
source. Continue turning actuator to
increase current level up to that set
on the welding power source Current
Control.
Turn actuator in the Decrease
direction as shown to reduce the
current output to zero, and turn off the
contactor.
Secure control to torch with velcro
straps.
4
RCC (Rotary Current And
Contactor Control)
5
14-Pin, 5-Pin Or 6-Pin Plug PLG2
Connect PLG2 to matching
receptacle on welding power source
as follows: align keyway, insert plug,
and tighten threaded collar.
188764G
Fsafe7 2013-10
Fsafe8 2013-10
Fsafe4 2013-10
802020