Miller DIVERSION 180 w/Auto-Line Manual del usuario - Página 18
Navegue en línea o descargue pdf Manual del usuario para Sistema de soldadura Miller DIVERSION 180 w/Auto-Line. Miller DIVERSION 180 w/Auto-Line 48 páginas. Wp - 17 torch
También para Miller DIVERSION 180 w/Auto-Line: Manual del usuario (40 páginas)
Imprimir página
4-1. Selecting A Location (All Models)
Movement
Location And Airflow
18 in. (460 mm)
18 in. (460 mm)
4-2. Remote Receptacle For Optional Foot Control
NOTICE − Use this receptacle to connect the dedicated optional foot control only. Connecting other types of equipment to this receptacle may damage
your machine.
8
1
805 113-A
OM-246 522 Page 14
SECTION 4 − INSTALLATION
1
3
18 in. (460 mm)
18 in. (460 mm)
Socket*
A
Foot Select
4
Socket Information
1
Command reference; +10 volts DC output to remote control.
2
0 to +10 volts DC input command signal from remote control.
3
Remote control circuit common.
4
15 volts DC.
6
Contact closure to 4 completes 15 volts DC contactor control
circuit.
5
Foot control select; jumper to 7 in foot control.
7
Chassis common.
8
Not Used
1
Handles
Use Handles to lift welder; get help
if necessary.
2
Cart
2
Place welder on cart to move unit.
3
Tipping
!
Do not move or operate unit
where it could tip.
4
Line Disconnect Device
Locate unit near correct input pow-
er supply.
Position unit so air can circulate.
For information about sources of
high-frequency see Section 8.
For carts and caster kits see back
of book or contact your distributor.
!
Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
805 475-A