Miller Swingarc DS-74S/D8 Manual del usuario - Página 24

Navegue en línea o descargue pdf Manual del usuario para Sistema de soldadura Miller Swingarc DS-74S/D8. Miller Swingarc DS-74S/D8 44 páginas.

Pressing the Jog/Purge switch allows the op-

erator to jog wire without energizing the weld

power or gas valve circuit.

• The unit provides the ability to jog the wire

feeder by means of the gun trigger or the

Jog/Purge switch. If the welding arc does

not initiate in 3 seconds after the gun trigger

is activated, the unit will perform a jog opera-

tion for a maximum of two minutes. If the gun

OM-1500-13 Page 20

SECTION 5 − OPERATION

trigger is still activated after two minutes, the

jog operation is terminated to prevent com-

plete despooling of the wire, in the case of

a damaged gun.

• The unit displays the "ERR TRIG" message

to inform the operator that the trigger is acti-

vated.

• Jog speed can be adjusted by the Adjust

control when the unit is jogging wire. The

Power Switch

Left/Right Select Switch

Pressing the Left/Right Select

switch allows the operator to

choose which side of the unit's con-

trols will operate.

Jog/Purge Push Buttons

Wire Speed Controls

unit displays jog speed when the unit is be-

ing jogged.

• Jogging can also be accomplished by

pressing the Jog/Purge button.

• Pressing the Jog/Purge button also allows

the operator to purge gas lines before weld-

ing and to preset gas pressure at the

regulator.

Ref. 803 183

Ref. 803 184