Miller ICE-55CM Manual del usuario - Página 10
Navegue en línea o descargue pdf Manual del usuario para Linterna Miller ICE-55CM. Miller ICE-55CM 38 páginas. Air-cooled torches for plasma arc cutting
Imprimir página
11. Sequence Of Operation For 12 Ampere Torch
EXAMPLE Of Cutting Operation
For shielded cutting, place drag shield on edge
of metal. For non-shielded cutting (non-CE
only), use 1/8 in (3.2 mm) standoff distance
(dragging tip will reduce tip life).
Adjust torch speed so
sparks go thru metal and
out bottom of cut.
OM-1593 Page 10
.
Moisture from the compressor will form in the air line and at
the torch. It will be normal to sometimes see moisture come
out the end of the torch.
!
The pilot arc starts immediately when trigger is pressed.
Raise trigger lock and press
trigger. Pilot arc starts.
Pause briefly at end of
cut before releasing trigger.
After cutting arc starts, slowly
start moving torch across metal.
Postflow continues for approx. 12 seconds
after releasing trigger; cutting arc can be in-
stantly restarted during postflow by raising
trigger lock and pressing trigger.
801 400-A