AquaOne HZS-200 Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Bomba de agua AquaOne HZS-200. AquaOne HZS-200 11 páginas. Swimming pool pump

Imprimir página

Seal all the connectors, unions and pump cover weil, avoid any dripping on

the motor,which would unfailingly damage it.

3. Controls prior to initial start-up

a) Check the main voltage and frequency are according to the label. Avoid

to use extended wire, try to use separate socket.

b) Verify that the pump shaft turns freely. Be sure that the earth leakage

protection is installed and earth cable is correctly made.

c) Fill the pump with water, make sure that the pump body, filter basket,

pipes and other connectors are not leaking. Tighten or loose the screws

with hands, or tolls if necessary.

d) Make sure the pumps are working with water in any case. Beiare initial

start up, fill the pump with water firstly for seif priming.

4. Start up

Start electrically the pump only when the suction and discharge pipes are

connected to the corresponding inlets and outlets. Do not tighten or loose

the screws when the pump is working. Please cut oll power

and contact with your distributors in case the pump can not working.

5. Maintenance and clean

Our pumps do not require any special maintenance or programming.

Regular clean the debris in the filter of pumps, avoid block the inlet pipe and

damage the pumps. In case the pump will be idle for a lang period of time, it

is recommended to disassemble, clean and store in a dry, weil- ventilated

place.

Technical Parameters

Model

Voltage

HZS-200

HZS-300

220V

HZS-700

By Aquaristikwelt24

Power

H-Max

200W

5.5m

300W

750W

11m

www.aquaristikwelt24.de

Output

Weight

5000 L/h

5kg

8000 L/h

5,5kg

14500 L/h

9,5kg

Dimensions

455×133×245mm

3m494×165×259mm

9 |

S e i t