Aquaox OXL5600-8 Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Sistemas de filtración de agua Aquaox OXL5600-8. Aquaox OXL5600-8 6 páginas.

AquaOx Protected Home

Caution: Diagram shown is for

reference purposes only. Read

installation and operation manual

prior to installing the unit.

SYSTEM INSTALLATION INSTRUCTIONS

*PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE BEGINNING

1. Find the point of entry of the main water line.

2. Determine where the drainage line will travel for the backwash process.

3. A 120-volt electrical outlet will be needed in order to plug in the Fleck 5600. Electricity is required to run

the timer only. Normal water pressure manually runs the backwash.

4. Place the filter where you want to install the unit. Be sure the tank is on a level solid base. Note: the system

cannot be tilted beyond a 70-degree angle. The system must be upright at all times.

5. Take care not to drop the system; the riser is sensitive to the weight of the media.

6. Perform all plumbing according to local plumbing codes.

7. It is important to use only Teflon tape on the by-pass valve.

Installation Steps:

1. Connect proper fittings to both sides, inward arrow and outward arrow on the bypass valve.

2. Turn both knobs on the by-pass valve clockwise until they are all the way open.

3. Ensure that the main water shutoff valve to the house is in the OFF position.

4. Cut the point of entry line to the house and install cutoff (A) as seen in the illustration.

5. From cutoff (A) connect line to the inward arrow on the bypass valve.

6. Install a hose bib on the line that runs from the outward arrow to the main line of the house.

7. From the hose bib install another cutoff (B) as see in the illustration.

INSTALLATION