Diamond 110/50 FTRE-CR Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Equipamiento alimentario comercial Diamond 110/50 FTRE-CR. Diamond 110/50 FTRE-CR 11 páginas.
Imprimir página
2.
PRELIMINARY INSTALLATION INSTRUCTIONS
The fry-top must be positioned in a well-aired room, if possible under a hood to remove
cooking steam thoroughly.
Before starting the appliance, remove all protective film; thoroughly clean the surfaces with a
soft cloth, lukewarm water and detergent, so as to remove all anti-rust products applied
during the manufacturing stage, then dry with a clean cloth.
If the appliance is installed near walls, partition walls, kitchen furniture, decorative panelling,
etc., these should be constructed with fireproof materials or a space of at least 100 mm
should be left free.
Make sure that fire prevention rules are strictly respected.
The appliances can be positioned - according to the models - as top or ground appliances, or
linked together with others of the series.
The main switch and the socket must be near the appliance and easily accessible.
Using the levelling feet lay the appliance flat, adjust the height and ensure its stability.
2.1
Regulations, technical rules and general specifications
Comply with the following rules during assembly:
1) accident prevention rules;
2) rules in force in the country where the appliance is installed;
3) carefully read this booklet as it contains important instructions about installation safety,
use and maintenance;
4) keep this booklet for further reference.
2.2
Installation
Installation, setting up and maintenance must be carried out by qualified personnel only.
Installation must be carried out in accordance with the rules in force in the country where the
appliance is installed.
The manufacturer declines all responsibility for incorrect functioning resulting from
defective installation, tampering, improper use, bad maintenance, non-observance of
the local rules and use by unskilled persons.
BEFORE POSITIONING THE APPLIANCE CONNECT THE POWER CABLE TO THE
ATTENTION!: For the 40-module as ground appliance
These appliances can be installed as single units. In this case they need to be fixed to the
ground. Please follow the instructions in the relative drawing.
INSTALLATION INSTRUCTIONS
APPLIANCE WITH WEIGHT GREATER THAN 40 Kg
TERMINAL BLOCK.