Aquaparx RIB-260 Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Barco Aquaparx RIB-260. Aquaparx RIB-260 5 páginas.

Assembly instructions / inﬂation/ deﬂation

Choose a smooth and clean surface to unfold your AQUAPARX inﬂatable boat. Inﬂate your AQUAPARX

boat with an AQUAPARX foot-pump or electric-pump, or any pump designed for inﬂatable boats, and other

low pressure inﬂatables. These types of pump will have a hose and adapters to ﬁt the valves on this

AQUAPARX. (connector is included in your repair kit)

a. Side tube valve(s), bottom ﬂoor and keel valve - please

see drawing to the right:

Unscrew the valve cap (1). Push button (2) in and turn

approximately 90 degrees so it is in

the "OUT" position.

Insert the pump hose end piece and inﬂate it until you will

reach the

required pressure. After inﬂation tighten all the valve caps

(clockwise). Only the valve(s) cap can ensure ﬁnal AIR

TIGHTNESS.

To release air from the side tubes and bottom ﬂoor tube,

remove the valve cap (1) and push button (2) in and turn

approximately 90 degrees so it is in the "IN" position. (3) :

valve base.

b. Max. air pressure : the correct pressure for this item is:

Side tube valve(s): 0,2 bar / 2,88 psi (=200 mBar ). Do not

exceed it.

c. Place your boat in carry bag along with equipment.

d. When storing your boat, keep it in a clean and dry

place.

Any use of an air compressor may result in poor performance or damage to the AQUAPARX boat, and

automatically voids all warranties. If you leave your A AQUAPARX boat exposed to the hot sun, check the

pressure and deﬂate it slightly. Otherwise the AQUAPARX boat may become over inﬂated and stretch the

material. The ambient temperature affects the tube's internal pressure : a variation of 1°C/ 1.8°F causes a

variation of the pressure in the tube of +/- 4 mBar (0.06psi)

Note: If you install a motor larger than the maximum rated horsepower for your boat, you might have

control problems and risk serious injury. Never exceed the maximum rated horsepower.

e. Whenever you take your AQUAPARX boat out of the water and deﬂate it, allow time for it to air out and

dry. Neither the skin/hull nor the inside chambers will suffer from water damage, but stagnant water could

cause mildew and foul odor. 