Diamond 393265 Manual - Página 8
Navegue en línea o descargue pdf Manual para Equipamiento alimentario comercial Diamond 393265. Diamond 393265 11 páginas.
Imprimir página5.1.6.1 SOLID TOP and COOKTOP MAIN BURNER
NOZZLE REPLACEMENT (simple service
version)
• Unscrew nozzle "C" and replace it with one suitable for
the type of gas (Table B, fig.3A, 3C) according to that
given in the following table.
• The nozzle diameter is given in hundredths of mm on the
nozzle body.
• Retighten nozzle "C".
5.1.6.2 COOKTOP PILOT BURNER NOZZLE
REPLACEMENT (simple service version)
• Undo screw coupling "H" and replace nozzle "G" with one
suitable for the type of gas (Table B, fig.3D).
• The nozzle identification number is given on nozzle body.
• Retighten screw coupling "H".
5.1.6.3 MINIMUM FLAME SCREW REPLACEMENT
SOLID TOP and COOKTOP (simple service
version)
• Unscrew minimum flame screw "M" from the cock and
replace it with one suitable for the type of gas (screw down
fully) (Table B, fig.2A).
5.1.6.4 MAIN BURNER NOZZLE REPLACEMENT
(oven)
• Remove the oven floor.
• Unscrew nozzle "C" (Table B, fig. 3E).
• Remove the nozzle and aerator.
• Replace nozzle "C" with one suitable for the type of gas,
according to that given in the following table.
• The nozzle diameter is given in hundredths of mm on the
nozzle body.
• Insert nozzle "C" into aerator "E", then fit the two
assembled components in their position, screwing down
the nozzle.
5.1.6.5 OVEN and SOLID TOP PILOT BURNER
NOZZLE REPLACEMENT
• Undo screw coupling "L" and replace nozzle "I" with one
suitable for the type of gas (Table B, fig.3B).
• The nozzle diameter is given in hundredths of mm on the
nozzle body.
• Retighten coupling "L".
6. BEFORE COMPLETING
INSTALLATION OPERATIONS
Use soapy water to check all gas connections for leaks. DO
NOT use a naked flame to check for gas leaks. Light all the
burners separately and also together, to check correct
operation of the gas valves, rings and lighting. For each
burner, adjust the flame regulator to the lowest setting,
individually and together; after completing the operations,
the installer must instruct the user on the correct method of
use. If the appliance does not work properly after carrying
out all the checks, contact the local after-sales service
centre.
20