Aquapeutics Mazatlan Manual de instalación - Página 10

Navegue en línea o descargue pdf Manual de instalación para Bañera de hidromasaje Aquapeutics Mazatlan. Aquapeutics Mazatlan 15 páginas.

Step 8

Step 6

ift the middle glass section ( with the sliding glass

door section)(two people are recommended) onto the

bathtub as shown in the photo, slip it into the

aluminum extrusions on the left and right sides,

making sure they bottom out into the vertical

extrusions. (You may have to tap them into place

with a rubber mallet) the complete glass wall and

back panel assembly should be able to stand by itself

without additional support. After the roof/ ceiling has

been secured, some final self-tapping screws will be

used to fasten the glass wall to the bathtub.

Step 9

All the panels and glass sections should still be loose or only

slightly hand tight. Lift the roof-ceiling section onto the top of

the shower assembly and align all the holes. Connect the roof

with the back-panel with 1/4 X 5/8 inch hex bolts, and connect to

the aluminum extrusions of the glass door frame with 3/16 X 5/8

self-tapping screws. Now snug up all fasteners (Except as

mentioned in step 9) while making sure the unit is plumb and

square.

Step 10

After the roof-ceiling has been secured, 2 self-

tapping screws will be used to fasten the glass wall to the

bathtub. Please pre-drill pilot holes through the extrusion (Two

people are recommended for this procedure, one to hold the

pieces in place while the other drills and screws the door frame

onto the bathtub) before screwing it in place. The photos below

(by way of the black lines) show recommended positions for the

screw holes but any two convenient places will do.