Chromalox Chroma-FP2 Manual de instalación y funcionamiento - Página 3

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Controlador Chromalox Chroma-FP2. Chromalox Chroma-FP2 13 páginas.

Imprimir página

Safety Precautions

IMPORTANT SAFEGUARDS

Safety precautions should always be followed to

reduce the risk of fire, electrical shock, injury and

even death to persons.

Please read all instructions before operating the

Control Panel.

HIGH VOLTAGE is used in the operation of

this equipment; DEATH ON CONTACT may

result if personnel fail to observe safety

precautions.

Learn the areas containing high-voltage

connections when installing or operating

this equipment.

Be careful not to contact high-voltage

connections when installing or operating

this equipment.

Before working inside the equipment,

turn power off and ground all points of

high potential before touching them.

To avoid electrical shock or injury, always remove

power before servicing a circuit. Personnel

working with or near high voltages should be

familiar with modern methods of resuscitation.

Contact an area supervisor or safety personnel

for more information.

ELECTRIC SHOCK HAZARD.Any installation

involving control equipment must be

performed by a qualified person and must

be effectively grounded in accordance with

the National Electrical Code to eliminate

shock hazard.

Before Powering Up

Chromalox takes great pride in knowing that we have provided to you a product of premium quality and

workman-ship. We have taken every precaution to ensure that your equipment arrives safe and secure.

However, vibration and temperature changes during shipping can cause some components to become

loose. Additionally, throughout the life span of this product, other environmental and application

conditions may have affected the mechanical and electrical continuity of several internal components.

Therefore, for your safety and overall product performance, please take the time to familiarize yourself

with the MAINTENANCE, OPERATION, AND INSTALLATION INSTRUCTIONS technical manual that

was shipped with your panel.

Since it is not uncommon for electrical wiring and mechanical connections to become slightly loosened

during shipment, we ask that you pay particular attention to the section titled Wiring and Connections:

WIRING AND CONNECTIONS

Check wiring and connections as follows:

a. Inspect wiring for wear, fraying, chipping, nicks, and evidence of overheating.

Repair minor defects with a good grade of electrical tape, or replace if needed.

b. Inspect for loose electrical and mechanical connections. Tighten or replace defective crimp-style

lugs. Re-solder loose solder connections. Tighten or replace all loose or missing hardware.