Diamond 8073140HCDIA Manual de instalación, funcionamiento y mantenimiento - Página 7
Navegue en línea o descargue pdf Manual de instalación, funcionamiento y mantenimiento para Equipamiento alimentario comercial Diamond 8073140HCDIA. Diamond 8073140HCDIA 19 páginas. Refrigerated counters
Imprimir página1.4 Installation
Before unpacking the appliance, check that the outer protective casing is fully intact.
Any damage must be promptly reported to the courier. In any case, no damaged appliance can be
returned to the manufacturer without prior notice and without prior written authorisation.
The described operations must be carried out by qualified personnel. Before performing any
installation procedure, disconnect the appliance from the power mains. Place the appliance in a
ventilated room away from heat sources, in order to ensure that there is a sufficient air supply in
the area housing the compressor. The refrigerated unit has been designed for use in a room with
a maximum temperature of 43°C. If the room temperature is higher, this may also have an effect
on the temperature of the appliance and may result in it malfunctioning or becoming damaged.
Set down the appliance where desired using a pallet truck. If the unit is moved after it has been
unpacked, protect the surfaces from knocks. Once the installation has been carried out, the protective
film can be removed. This operation should be performed very slowly to prevent the glue from remaining
on the surfaces.
The equipment is supplied with adjustable feet to obtain the desired height and compensate for any
unevenness or slope of the floor.
WARNING: Do not obstruct the holes made in the units to ventilate the technical compartment; any
obstruction could cause the appliance to malfunction.
WARNING: Do not store or use flammable materials and liquids near the appliance, and do not use
electrical devices inside the compartments.
Use an earthed socket with an adequate capacity for the absorption indicated on the rating plate.
Before installing the appliance, check the flatness of the floor. Incorrect levelling can cause the appliance
to malfunction.
1.5 Electrical connections
They must be carried out in accordance with the local regulations in force. Before performing the
electrical connection, make sure that the voltage and frequency correspond to the information
indicated on the appliance's rating plate. The electrical connection is carried out by connecting
the appliance's plug to a socket in the room; this socket must still remain accessible after the
installation.
The cable must have the minimum properties of a type H05 RNF cable and an efficient, appropriately-
sized earthing conductor based on the total power of the appliance and any other appliances or
accessories connected on the same terminal board (see the rating plate).
If the power cable is damaged, it must be replaced by the customer service or qualified personnel.
The appliance's electrical supply system must be equipped upstream with an appropriately-sized
automatic omnipolar circuit breaker that ensures a gap of at least 3 mm between the contacts. There
must not be any breaks in the earth cable.
The electrical safety of this appliance is only guaranteed when the above-mentioned conditions
are met and if the system's equipotential situation is also compliant (use the connection screw
located near the power cable input and the symbol sticker).
Any operations carried out on electrical systems must be performed by qualified personnel.
The manufacturer declines all responsibility in the event that these safety standards are not
complied with.
A010046R290 Rev.1
Page 18 of 56