AQUAPHOR DWM-31 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Sistemas de filtración de agua AQUAPHOR DWM-31. AQUAPHOR DWM-31 17 páginas. Drinking water machine

AQUAPHOR DWM-31 Manual de instrucciones
5. DWM INSTALLATION GUIDE*
ATTENTION! The DWM installation must be carried out by experts with permission to do plumbing works.
ATTENTION! Before installation, measure the waterline pressure and, if it exceeds 0.63 MPa (6.5 atm), put
the pressure regulator with non-flow working mode (not supplied in the standard equipment).
Determine the convenient location for the clean water tip, working unit, installation location for the
connection assembly to the water supply and drain clamp.
Note that the water connections come through freely, without bending.
Free connection parts must be fixed in such way so that they cannot be damaged or pulled out of the
sockets by foreign bodies.
The DWM must be distanced or isolated from heat sources (such as dishwashers and washing machines,
cookers, boilers, hot water pipes, etc.).
Install the collection bowl in the place, where the water pouring over the edges cannot lead to undesirable
consequences (for electrical appliances, not water-resistant surfaces, etc.).
Installing the connection assembly (Fig. 3)
Turn off the water.
Open the kitchen mixer to relieve the
pressure in the waterline.
Connect the connection assembly to the
waterline.
If necessary, use a FUM tape to seal the male
thread of the connection assembly.
Connect the tube JG 1/4". In order to do this,
remove the clip under the plastic bushing;
insert a pre-dampened end of the tube into
the bushing fitting all the way to the depth of
about 20 mm and install the clip into place.
Check the holding strength of the tube fixing:
the tube should not be removable by a force
of 8-10 kgf applied.
* Manufacturer reserves the right to use the components of similar design
4
Figure 2
Cold water supply
Figure 3