3B SCIENTIFIC CPRLilly P70 Manual - Página 15

Navegue en línea o descargue pdf Manual para Productos para la enseñanza de las ciencias 3B SCIENTIFIC CPRLilly P70. 3B SCIENTIFIC CPRLilly P70 19 páginas.

Imprimir página

General safety instructions

• The CPRLilly™ and CPRLillyPRO™ packaging is not a toy – there is a risk of suffocation!

• Intubation is not possible

• Do not „fish around" for the throat bag with sharp objects (such as a knife)!

• The CPRLilly™ or the CPRLillyPRO™ should not be used near open flames.

• Do not use the CPRLilly™ or CPR CPRLillyPRO™ outside in heavy rain

• Do not plunge the CPRLilly™ or CPRLillyPRO™ under water

• Do not use sharp objects to operate the touch screen

• Joint in the head: Do not remove the studs (risk of injury)

• When in operation, „noises" will occur. This does not mean that the simulator is not working properly!

• Important! Do not press on the abdomen area. There is a risk of damaging the electronics.

• The CPRLilly™ or the CPRLillyPRO™ should only be used for artificial respiration if a throat bag has been inserted

• It is not advisable to change the bag in the rain (water can enter the inner respiratory system of the CPRLilly™ or the

CPRLillyPRO™)

FAQ

• Can I use my own song for the simulation?

No.

• Where do I choose the languages?

In the settings window under the language section

• How do I switch the acoustic rhythm output to the song?

In the settings window under the section 100 bpm rate

• Where can I find the silence button?

You can find this in the simulator window if the teaching mode has been activated

• What do the colours on the LED button mean?

green light → The CPRLillyPRO™ is switched on and ready for use

no light → CPRLillyPRO™ is switched off

green-red flashing light → the battery is almost flat

flashing slowly orange → the battery is charged

flashing quickly orange → the battery is being charged

flashing red only → device error

• What should I do if the LED is flashing red?

Remove the USB cable from the device

Hold the LED button down for five seconds until the device switches off.

Plug the cable back in and press the LED button.

If, after trying the LED button several times, the red light keeps flashing, contact your supplier.

• How do I set up a Bluetooth connection to the BLS simulator?

Please go to the tablet settings and look for Bluetooth, then activate Bluetooth.

The Bluetooth connection is switched on and configured upon leaving the factory.

• Is the simulation data lost if I accidentally touch the start screen button (home button)?

Unfortunately, the simulation will be lost if you do this. The program is stopped and must be restarted.

• Why can I not breathe into the CPRLilly™?

The head has not been tilted back. Tilt back the head to enable respiration.

The volume of the air contained inside is not sufficient. Please remove the throat bag briefly

in order to fill the breathing system with air