BURL B80-BMB3 MOTHERSHIP Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Equipos de grabación BURL B80-BMB3 MOTHERSHIP. BURL B80-BMB3 MOTHERSHIP 15 páginas. Bmb3 rev c rom 1

Imprimir página

1. GETTING STARTED

1.1 Register

Please register all serial numbers for your B80 MOTHERSHIP chassis, all Daughter Cards,

and BP-300.

You must register to activate your warranty! Please visit: www.burlaudio.com/register.

1.2 Check Jumper Settings On BMB3

The B80 MOTHERSHIP is fully modular, accommodating a wide variety of I/O needs. Jumper

settings on the BMB3 Motherboard allow for different I/O routing possibilities.

Find H8 on the BMB3 Motherboard, as shown in Image 1 below.

Use Examples A through D (on pages 2 and 3) to determine which setting to use based

on your configuration.

See Channel Mapping for Jumper Settings charts on page 4.

Jumper positions 1 and 2 determine the INPUT channel mapping, this allows you to set

the configuration for each card slot in the MOTHERSHIP.

(Configurations possible: 4 Ch. per slot / 8 Ch. per slot / 8 and 4 Ch. per slot).

Jumper positions 3 and 4 determine the OUTPUT channel mapping, this makes it so you

can set where our OUTPUTS start in the MOTHERSHIP chassis.

(Output can start in slots 3, 5 & 7)

Jumper positions 5, 6 and 7 have no function.

(Jumpers can be kept here for safekeeping when not in use)

Jumper 8 is for use with the B16 MOTHERSHIP chassis, and should not be used with

the B80 MOTHERSHIP chassis.

Image 1: Locating the H8 Header on BMB3 Motherboard: From the rear of the chassis,

BMB3 is on the far left. The H8 Header is highlighted. In this example, jumpers are on 1 and 3.

SECTION 1