Aquaport AQP-3TAP-SS Manual de instrucciones de instalación y funcionamiento - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Dispensador de agua Aquaport AQP-3TAP-SS. Aquaport AQP-3TAP-SS 16 páginas. Platinum water dispenser hot/cold & room
También para Aquaport AQP-3TAP-SS: Manual de instrucciones de instalación y funcionamiento (16 páginas)
Imprimir páginaB. Platinum Water Dispenser Installation for Water Filter bottles
Please follow the instructions below if you are using a Water Filter
Bottle.
Do not turn on the water cooler until the following instructions have
been followed.
1. Remove the bottle support and spike from the water cooler.
See figure 1.
2. To remove the bottle supporter, turn it anti-clockwise to unlock
and lift up.
Note:
The bottle supporter can be difficult to remove due to
the clean air seal, so a bit of force is required to pull the bottle
supporter off the water cooler.
3. When the bottle supporter is removed you should be able to
see inside the stainless cooling tank, and a white water baffle
(water divider).
4. Follow the instructions that come with the water filter bottle for
correct installation.
5. Place the filter bottle on top of the water cooler and fill as per
the instruction in the water filter bottle user manual.
4 INSTALLATION AND OPERATING INSTRUCTIONS
Note:
Filter bottles generally have a slower flow rate compared
to spring water bottles, hence it will take longer to fill the cooling
tank. Allow the cold tank to fill for 30 minutes before following
Steps 2-6 as explained in section A) Platinum Water Dispenser
Installation for Spring Water bottles.
Fig 1
Bottle Support