Aquaport AQP-FKM2 Manual de instrucciones de instalación y funcionamiento - Página 12
Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Sistemas de filtración de agua Aquaport AQP-FKM2. Aquaport AQP-FKM2 17 páginas.
Imprimir página
FILTER REPLACEMENTS
1. Isolate water supply, by turning the shut off valve 'off' or
turning water 'off' at the mains water supply. Open tap faucet
to release any excess water still present in system.
2. Remove new filter cartridge(s) from packaging.
3. Remove corresponding old cartridge from system, by rotating
the filter counter clockwise a 1/4 turn and pull out. See Fig 3.
4. Replace new cartridge(s) into the filter head and rotate
clockwise a 1/4 turn, to lock filter into place, ensuring they
are in the correct positions.
5. Turn faucet to 'ON' position. Turn water supply 'ON' slowly at
isolation tap or water meter, to release any air trapped in the
system.
6. Leave faucet in the 'ON' position for approximately 2 minutes
to allow water to fully flow through the system.
7. Turn faucet 'OFF', and check for any water leaks around the
system.
8. Turn faucet 'ON' and leave in the 'ON' position for
approximately 5 minutes to allow water to flush out the
system.
10 INSTALLATION AND OPERATING INSTRUCTIONS
Repeats steps 1-3 for all other cartridges for double or triple
stage systems. Please check system again the next day after
installation for any leaks.
Note: Use only cartridges suitable for this appliance.