Burlington TF1H Manual de instrucciones de instalación - Página 4

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Sanitarios Burlington TF1H. Burlington TF1H 6 páginas. Trent thermostatic single outlet concealed shower valve with rail, hose and handset

Imprimir página

SHOWER HANDSET

The valve should be installed in accordance with the water bye-laws. For further details refer to the latest copy of Water Bye-laws guide

or your local water authority.

Note: Please check for any hidden pipes and cables before drilling holes in the wall.

The fitting of isolation valves is required as close as is practicable to both hot and cold water supply inlets.

1. Put the valve (make sure the two protective sleeves are protecting the chrome section) onto the wall and mark the position of the fixing lugs (X2).

2. Make sure the valve is set back from the front face of the wall by the appropriate depth to allow for plasterboard, tiling and filling etc.

(min. 75 to max. 90mm)

3. Mount the valve to the wall using suitable fixings (see Fig 1).

4. Inlets and outlets are all tapped 3/4". Make all the pipe work connections using a thread sealer. Don't use the tapered threaded adaptors.

5.Outlet at the top of valve is recommended for shower only, the pipe connection is recommended as the diagram above (see Fig 1).

That will be convenient for taking off the valve for easy maintenance.

6. Turn on supplies and test all connections for water tightness. (if necessary, the filter and check valve need to be cleaned)

7. Then install the plasterboard and tile the wall.

8. Remove the adhesive tape film on the backside of back plate. Paste the back plate on the wall (see Fig 2).

9. Apply a narrow bead of silicone sealant around the back edge of the back plate and carefully press into position.

10. Mount the handles into position (see Fig 3).

11. Connect the elbow with the outlet (see Fig 4).

12. Connect the hose nut end with the elbow (see Fig 5).

13. Connect the hose cone end with the shower handset (see Fig 6).

14. Make sure the shower hook at a suitable position, fix it onto the wall (see Fig 7).

HOSE CONE END

WASHER

4 - 6