AquaRest Spas AR-600 EZB Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Bañera de hidromasaje AquaRest Spas AR-600 EZB. AquaRest Spas AR-600 EZB 20 páginas. Uhs spa

Spa water chemistry (or water balance) affects the safety of your equipment as well as the appearance of your spa

water. Water balance has five factors: pH, total alkalinity, calcium hardness, temperature and total dissolved solids.

pH is the most critical but total alkalinity and calcium hardness must also be watched closely. Low calcium hardness

can lead to corrosion of equipment, while high calcium hardness can lead to scaling, cloudy water and staining. Water

temperature should never exceed 104°F (40°C), and total dissolved solids should be kept below 1500 PPM.

Algicidal and sanitizing chemicals are either alkaline or acid. Sodium and calcium hyprochlorites are alkaline. Chlorine

gas and practically all other dry chlorine spa products are acid. On the market are a number of bromine sanitizers.

Bromines are usually preferred since they don't emit a strong chlorine odor.

1. Check and adjust water conditions. You must maintain proper chemical balance to insure safe sanitary conditions

and to prevent your spa from becoming a breeding place for bacteria. This is done by:

A. Test daily and maintain pH between 7.2 and 7.8. Adjust if necessary, above 7.8 use pH decrease, if below 7.2 use

pH Increase. Improper pH can damage spa finish, equipment, cause eye irritation and chemical loss. Use dosage

according to manufacturer's label.

B. Test alkalinity and maintain at 80 ppm to 140 ppm. Adjust if necessary, above 140 ppm use pH Decrease, if

below 80 ppm use Total Alkalinity Control. Use dosage according to manufacturer's label.

C. Test daily and maintain proper sanitizer level. It's recommended to use bromine sanitizer and maintain bromine

at 3.0

5.0 ppm. Typically two or three bathers relaxing in an average spa with 103°F (39°C) temperature will consume

all the bromine sanitizer in about twenty minutes. Therefore, prolonged or heavy use may require additional

bromine to maintain safe sanitary conditions.

D. "Shock" (with a non-chlorine shock) once a week and after each water change. Do not use spa until the bromine

residual has dropped to less than 5.0 ppm. NOTE: Improper pH will cause early corrosion to your pump.

Corrosion is not handled under any warranty.

SPA MAINTENANCE SCHEDULE

DAILY

Test and maintain pH: Ideal range 7.2 - 7.8b.

Test and maintain bromine: Ideal range 3.0 - 5.0

WEEKLY

Test and maintain alkalinity 80 - 140 ppm. Shock with a non-chlorine shock.

Add Spa Clear.

MAINTENANCE

Add defoamer as needed.

Inspect filter cartridge every 2 weeks and clean when needed.

SEE YOUR SPA WATER EXPERT FOR ADDITIONAL

Damage due to improper chemistry will void warranty

ppm.

INFORMATION