Aquasana AQ-5300.62 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Sistemas de filtración de agua Aquasana AQ-5300.62. Aquasana AQ-5300.62 9 páginas. Under sink

Imprimir página

FILTER REPLACEMENT

Once filters are at 95% capacity (about every 6 months), the battery alarm will

sound when water is flowing then will continue to sound for 15 seconds after

water is turned off. The battery will need to be replaced every time the filters

are replaced. A battery is included with the filter replacement cartridges.

1. Shut off the cold water valve under the sink. Release the pressure from

the system by turning on the dedicated faucet. Once there is no longer

any water flowing, you can proceed with replacing the filters.

2. Unbox filter replacements and remove plastic. Each filter is color coded

to match the circle indicator on each filter housing.

3. Remove each filter housing from the system manifold

by turning the filter housing to the left. Pull down to

detach. Ensure the filter housing are not on an angle

while removing. This may result in damage to the o-ring.

4. Holding the filter housing over the sink, open it by

turning the bottom counterclockwise. Pour excess water down sink drain.

Pull down on dirty filter to disconnect it from the filter housing. Continue

this step for each filter housing. While the

housing is open, inspect each o-ring for

damage. If misaligned, gently move

the o-ring into place.

NOTE: If filter housing is too tight to

disconnect by hand, please use the plastic

wrench included with original system.

NOTE: The filter housing must be replaced

every five years. Failure to do so could

result in potential leaks due to product

deterioration. To order, please call

Customer Support at 866-662-6885.

5. Press new replacement filter to the top of the filter

housing using the appropriate color coded filters.

Then, reconnect the bottom of the filter housing to

the top half. Ensure connection points are correctly

aligned, then turn clockwise to tighten. Continue this

step for each filter housing.

NOTE: Do not use tools to

tighten. Hand tighten only.

6. Reattach filter housing to bottom of the system manifold. Ensure

connection points are correctly aligned, then push the filter

housing up while turning clockwise. Continue this step for each

filter cartridge. Ensure all filter housings are not at an angle while

reattaching. This may result in damage to the o-ring.

7. Open battery door and remove old battery. Insert new battery. When inserted

correctly, system will beep five times and blink red.

8. Once all filter housings have been replaced and attached, slowly turn water valve

on. Turn off faucet and inspect for leaks. Then, flush system for 10 minutes before

drinking.

AQ-5200

AQ-5300

Red • Yellow

Black • Red • Yellow

AQ-5200R

AQ-5300R

Scan to view AQ-5200R

Scan to view AQ-5300R

replacement video.

FILTER REPLACEMENT

AQ-5300+

Green • Red • Yellow

NOTE: Do not drink flushed water.

AQ-5300+R

Scan to view AQ-5300+R

replacement video.