Panasonic AGDVC200 - DV CAMCORDER Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Videocámara Panasonic AGDVC200 - DV CAMCORDER. Panasonic AGDVC200 - DV CAMCORDER 44 páginas. Digital video camera recorder
También para Panasonic AGDVC200 - DV CAMCORDER: Manual de instrucciones (45 páginas), Especificaciones (4 páginas)
Imprimir página
Parts and their functions
?
<
;
:
9
8
1
CC/ND filter selector knob
This is used to select the filter to match the subject brightness.
1 :3200K
2 :5600K+1/8ND
3 :5600K
4 :5600K+1/64ND
2
Lens lever
This lever is tightened to secure the lens after the lens has been
attached to the lens mount.
3
Lens mount (bayonet type)
The lens is attached to this mount.
4
AUTO W/B (white/black) BAL switch
AWB: The white balance is automatically adjusted. When the
AWB memory selector switch on the side panel is set to A
or B and then the AUTO W/B BAL switch is operated, the
adjustment value is recorded in the memory. Bear in
mind that the switch does not work when it is set to the
ATW or PRST position.
ABB: The black balance is automatically adjusted.
5
SHUTTER switch
This is the ON/OFF selector switch of the electronic shutter.
OFF : The electronic shutter does not operate.
ON : The electronic shutter operates.
SEL : This is used when the electronic shutter speed is to be
changed. The switch is a non-locking type. The shutter
speed changes each time it is operated. For further
details, refer to "Electronic shutter settings" (page 21).
6
VTR START/STOP button
This starts or stops the video recording.
7
LENS jack (12-pin)
The connecting cord of the lens is connected to this jack. For
further details on the lenses that can be used, refer to the
operating instructions of the lenses concerned.
@
>
=
1
2
3
4
5
6
7
8
MIC IN (mic input) jack (XLR, 3-pin)
The accessory microphone is connected to this jack. The power
for the microphone is supplied from this jack.
9
AUDIO OUT jacks (pin jacks)
An audio component is connected to these jacks. The sound for
channel 1 and channel 2 is output separately.
:
GENLOCK IN connector (BNC)
Supply the sync signal (black burst signal) to this connector
when gen-locking the camera pictures (CAM OUT jack) of the
unit.
;
CAM OUT jack
This is the dedicated output jack for the camera's pictures.
<
S-VIDEO OUT jack (Y/C jack)
When pictures are to be recorded with a backup VTR connected
to the S-VIDEO OUT jack, bear in mind that the unit's playback
pictures will be recorded onto the backup VTR if any operation
(such as REC CHECK) that performs VTR playback is
executed.
=
Viewfinder connector
The viewfinder plug is connected to this connector.
>
Viewfinder stopper screw
This screw is used to secure the viewfinder.
?
Light shoe
The video light or other such device is attached here.
@
Shoulder belt fittings
The shoulder belt (optional accessory) is attached here.
8