AquaScape 96031 Instrucciones y mantenimiento - Página 3
Navegue en línea o descargue pdf Instrucciones y mantenimiento para Sistemas de filtración de agua AquaScape 96031. AquaScape 96031 16 páginas. Automatic dosing systems for ponds/ fountains
También para AquaScape 96031: Manual de instrucciones y mantenimiento (20 páginas), Instrucciones y mantenimiento (20 páginas), Manual de instrucciones y mantenimiento (20 páginas)
Imprimir página
Introduction
The Aquascape Automatic Dosing System when used in
conjunction with the Aquascape Automatic Dosing System
water treatments will provide pond and water feature owners
with optimum water conditions and crystal-clear water.
The Aquascape Automatic Dosing System was designed
to take the guesswork and mundane chore out of adding
water treatments to your pond or fountain on a consistent
Contents
No.
Description
1.
(1) Automatic Dosing System
2.
(1) 6 W transformer
3.
(1) Discharge tubing (6')
4.
(1) Output Hose Holder
5.
(1) Water Treatment
Safety Information
WARNING: Risk of electric shock – This
Product has not been approved for use
in swimming pool or marine areas.
WARNING: To provide continued protection
against risk of electric shock, connect to
properly grounded, ground fault circuit
interrupter (GFCI) outlets only, using the
following guidelines:
(A) This product is weatherproof, but is not designed to
be submersed in the water.
(B) Have a qualified electrician install a properly grounded
receptacle outlet, acceptable for outdoor use when
protected from direct sunlight snow and rain. If
possible locate the outlet or filter so that the power
cord will reach the outlet without an extension cord.
www.aquascapeinc.com |
☎
Contents
3
5
CAN 1-866-766-3426 |
☎
and regular basis. Adding water treatments consistently
and often ensures pristine water conditions both visually
and optimizes water conditions for pond inhabitants. This
Instruction Manual will guide both your installation of this
filter and recommended maintenance procedures to ensure
long-term effectiveness.
1
(C) Inspect cord for damage before using.
(D) If an extension cord is required be sure it is rated for
outdoor use.
(E) Any wiring of this product should be performed by a
qualified electrician to ensure code compliance and
user safety.
(F) To reduce risk of electrical shock, all wiring and
junction connections should be made per local
codes. Requirements may vary depending on usage
and location.
(G) The power cable should be protected at all times to
avoid punctures, cuts, bruises and abrasions.
(H) Never handle power cords with wet hands.
(I) Unplug filter at receptacle outlet when not in use.
(J) Do not remove cord and strain relief. Do not connect
conduit to product.
(K) Do not use power cable to lift the Automatic
Dosing System.
US 1-866-877-6637
2
4
3