Diamond 60/90 PCG Series Instalación - Uso - Mantenimiento - Página 7

Navegue en línea o descargue pdf Instalación - Uso - Mantenimiento para Gamas Diamond 60/90 PCG Series. Diamond 60/90 PCG Series 19 páginas. Range, gas solid top

Imprimir página

Connect the power supply cable to the terminal

board as shown in the wiring diagram supplied

with the appliance.

Secure the power supply cable with the cable

clamp.

Protect the power supply cable on the outside of

the appliance with a rigid plastic or metal pipe.

If the power supply cable is damaged, it must be

replaced by the manufacturer or his service centre

or by a person with similar qualifications to

prevent any risk.

THE SYMBOL " HIGH VOLTAGE" IS

PLACED ON A PANEL THAT GIVES

ACCESS TO A PART WITH HIGH

VOLTAGE.

PROTECTIVE EARTH AND EARTH BONDING

CONNECTIONS

Connect the appliance to an efficient ground

circuit. Connect the earth conductor to the

terminal with the symbol

terminal board.

Connect the metal structure of the appliance to

the equipotential node. Connect the conductor to

the terminal with the symbol

part of the bottom.

CONNECTION TO THE WATER SUPPLY

The appliance must be connected to a potable

water supply. The water inlet pressure must be

between 150 kPa and 300 kPa. Use a pressure

reducer if the inlet pressure is above the

maximum permitted level.

Install a mechanical filter and a shut-off valve

upstream of the appliance in an easily accessible

point.

Make sure the water circuit is free of ferrous

particles before connecting the filter and the

appliance.

Seal any unused connectors with a plug.

Once the appliance has been installed, check for

gas leaks at the connection points.

CONNECTION TO THE WATER DRAIN

The water drainage system must be made using

materials resistant to temperatures of 100 °C. The

bottom of the appliance must not be subjected to

steam produced by drainage of hot water.

Install a siphoned floor drain with grating below

the water drain cock of Boiling pans and in front of

Bratt pans.

next to the main

on the outside

8. CONVERSION TO ANOTHER

TYPE OF GAS

Table Tab1 specifies:

which gas can be used for the appliance.

the nozzles and settings for each gas that can be

used.

For nozzles, the number indicated in table TAB1 is

also stamped on the body of nozzles.

To convert the appliance to the local gas type,

follow the instructions given in TAB1 andcarry out

the steps below:

Replace the main burner nozzle (UM).

Adjust the main burner's air regulator to distance

Replace the pilot burner nozzle (UP).

Adjust the pilot burner air " ow (if necessary).

Replace the gas valve minimum nozzle (Um).

Affix the adhesive tab indicating the new type of

gas used.

The nozzles and adhesive tabs are supplied with

the appliance.

GAS HOB

REPLACING THE MAIN BURNER NOZZLE

Remove the control panel.

Remove pan stand grids, basins and burners.

Remove nozzle UM and replace it with the one

indicated in table TAB1.

Retighten nozzle UM.

Reassemble all parts. For assembly, proceed in

reverse order.

REPLACING THE MINIMUM ADJUSTMENT SCREW