Chuango SPS-260 Manual del usuario - Página 2
Navegue en línea o descargue pdf Manual del usuario para Producto de seguridad para el hogar Chuango SPS-260. Chuango SPS-260 3 páginas. Solar-powered siren
Imprimir página
Work as an Alarm Panel
Connect with Wireless Accessories
Press the learning button (0.5 seconds), the system goes into connecting status after one beep is heard.
Press test button on accessories or trigger the accessory once. The wireless accessory is connected
successfully after another beep. To give up the connection, press the learning button again to exit
connecting status after one beep.
After connected with wireless accessories, the siren will hoot and the strobe light will flash to deter the
burglar on site when the accessories detect intrusion.
Note:
No matter the siren works as a wireless siren or an alarm panel, if disarm is not operated after the
siren duration time, the status indicator of siren will flash once every 2 seconds to inform user or patrol
police that the alarm system has been triggered. This LED indication lasts for 1 hour.
Enter/Exit Connecting Status by Connected Remote Control
When the siren is working as a standalone alarm system and installed on the wall, newly purchased
accessories may not easy to connect with the siren. With this function, user can easily connect the
accessories to the siren without dismounting the siren from the wall.
1.
Press
on the remote control 3 times (within 5 seconds) to enter service mode.
2.
Then press
3 times (within 5 seconds) to enter connecting status.
A longer beep is heard from the siren means it enters connecting status, press test button on the newly
purchased accessory or trigger the accessory once. Another beep is heard from the siren, the accessory
has been successfully connected with the siren.
Press
on remote control to exit connecting status after a short beep.
Installation
Service Mode
The service mode is to prevent triggering the alarm when you mount the siren on the wall.
When the remote control is connected with the siren, press
seconds), the siren goes into service mode when a long beep is heard. During this period, the siren will
not alarm but beep even if the tamper switch or the sensors connected are triggered. This brings you
convenience on installation.
Press
on remote control to exit service mode after a short beep.
on remote control 3 times (within 5
Remove the fixing
screw from the bottom
edge of the siren
housing and carefully
remove front cover.
Drill four holes and
fit the wall plugs,
and then fit
supplied fixing
screws in the
holes.
Specifications
Backup Power
18650 3.7V 1200mAh rechargeable lithium battery x 1
9V 6F22 battery x 1
2000LUX illumination ≥4mA (in sunlight)
Solar Panel Output Current
≤500mA
Maximum Alarm Current
≤80m (in open area)
Wireless Receiving Distance
Operation Condition:
Temperature -10℃～+55℃
Relative Humidity ≤80% (non-condensing)
Maximum Siren Volume
110dB
≤1mA
Static Current
Standby Time
≤30 days (in case of no sunlight)
Wireless Receiving Frequency
315MHz or 433.92MHz ( ±75KHz)
Housing Material
PC + ABS + ANTI-UV
Size (L x W x H)
309 x 230 x 79.7mm
Hold the mounting
plate in position and
mark the positions of
the four mounting
holes. A spirit level
placed on the water-
proof casing will ensure
a perfect level.
Hinge the front cover
locating tabs over the top
edge of the back plate and
carefully push the base of
the siren cover into place.
Secure the siren cover in
place by refitting the fixing
screw in the bottom edge
of the cover.
Ver : SPS-260-EN-1407-V2.0-1
2014 Chuango. All Rights Reser ved.