AQUASONIC AQ339 Manual de instalación - Página 8

Navegue en línea o descargue pdf Manual de instalación para Altavoces AQUASONIC AQ339. AQUASONIC AQ339 12 páginas. Underwater loudspeakers
También para AQUASONIC AQ339: Manual de instalación (12 páginas)

Imprimir página

Carefully remove the speaker from its box. Install the mounting gasket around the rubber ring of the sound

lens (as shown below). Insure the mounting gasket is installed evenly and is firmly seated against the entire

circumference of the sound lens.

Place the speaker on a non-abrasive surface with the sound lens facing up. Hold the face ring above the

sound lens, allowing the clamp tabs to fall open. Set the face ring against the mounting gasket, insuring

each clamp tab is on the outside of the mounting gasket. Hold the entire assembly together and place it

on the non-abrasive surface as shown in the third picture below. Carefully position the sound lens so it is

centered over the face ring.

Pull the bundled speaker wire through the wire clamp. Place the wire clamp under each clamp tab, verifying

the nut and bolt adjuster is accessible when the clamp is placed under the tabs. Insure the mounting gasket

and face ring are still evenly centered.

Underwater Speaker