Diamond Antenna D130J Manual de instrucciones
Navegue en línea o descargue pdf Manual de instrucciones para Antena Diamond Antenna D130J. Diamond Antenna D130J 2 páginas. Super discone antenna for wideband reception
También para Diamond Antenna D130J: Manual de instrucciones (1 páginas)
Imprimir página
OPERATING MANUAL
0130J/0130NJ Super Oiscone Antenna for Wideband Reception
The 0130J/D130NJ Super Discone Antenna is
the first ultra-wideband antenna in the market
which can cover amateur radio, air traffic
control and other various utility frequency
bands and, in addition, even some amateur
radio frequency bands within the covering
frequency range can be transmitted with this
antenna
alone.
The
D130J/D130NJ
is
designed to be able to assemble very easily
and can be built in a couple of hours by
beginners.
Rust
free
stainless
steel
is
employed in major component parts to have
the antenna rust resistant and durable. And its
very compact and lightweight design enables it
to be installed at any convenient place.
Assembling the 0130J/0130NJ Super Oiscone Antenna
Description
1. Ultra-wideband design to be able to cover
25-1300MHz.
2. Very compact and lightweight design
enables the antenna to be installed on
balcony railing at an apartment or
condominium.
3. 6m, 2m 70cm and 23cm amateur
frequency bands and 33cm band
(900MHz) can be transmitted.
4. Since all radial rods are designed to have
the same length, the D130J/0130NJ is
perfectly omnidirectional as original
discone antenna and can receive radio
propagation from any direction evenly.
5. The D130J/0130NJ can be made further
compact and lightweight by removing the
top element assembly, if
it
doesn't require
to receive lower end frequency range.
Specifications
Frequency range: 25-1300MHz for receiving
only (Amateur frequency
bands and personal radi.o
frequency band for trans-
mitting)
Length
:1.7m (66.9")
Weight
:1kg (2.21bs.)
Max. Diameter
: 0.84m (33")
• Number below each part name
is a part number
• Coaxial cable is not included.
Set screw
01010
Spring washer -
01011
~-----~-~
Hexagonal wrench
---~"""
01008
Set screw 01009
Turn set screw until it stops lightly
and then turn it about one and
half turn to fix radial element rod
and to avoid disconnecting the
element.~
Filled part
of
each radia
/
V
. . . . . - , ,
element rod has to be
set upward.
.....___
______ _
/
Radial
element rod
,,
820mm (32.3") /
I
01005
I
\
J
!
'
/~:ch
cap has to be
'
attached to the empty
side of the rod.
r
Cap(small)
01015
L T o p element
11
01001
Disc element rod 01004
280mm ( 11.0")
These disk element rods have to be assembled
after radial rods have been assembled.
After putting apex assembly out from the package,
detach support pipe from the assembly by removing
three M3 screws. Then connect coaxial cable to
coaxial receptacle at the bottom of apex assembly
through support pipe as shown in the illustration.
--~--
Applical91e mast diameter
25 to 52mm (0.98 to 2.05")
V-bolts
Mast diameter accepted: 25-50mm (0.98" to 2.05")
Max. Power rating: 20W FM (6m), 50W PEP (6m)
200W FM (except for 2m)
Coaxial cable is not included.
Type
: Wideband Omnidirectional
discone antenna