Panasonic WV-SC385 Manual de instalación - Página 18
Navegue en línea o descargue pdf Manual de instalación para Videocámara Panasonic WV-SC385. Panasonic WV-SC385 36 páginas. Ip video cameras
También para Panasonic WV-SC385: Especificaciones (2 páginas), Manual de instalación (40 páginas), Cuadro comparativo (6 páginas), Manual de instalación (40 páginas), Manual de instalación (40 páginas), Nota de integración (8 páginas)
Imprimir página
Guide part
Lock plate
Moving part
Camera
Important:
• When mounting the camera onto the camera mount
bracket, hold the base part of the camera. Mounting
the camera while holding the moving part may result
in malfunction.
Step 7
Fix the camera on the camera mount bracket (accessory)
using the camera fixing screw (accessory).
Recommended tightening torque: 0.68 N·m
{0.50 lbf·ft}
Fixing screw
(accessory)
18
Center of the
camera mount bracket
Base part
Camera mount bracket
(accessory)
Step 8
Connect the cables to the network connector and the
power inlet.
Important:
• When the power of the camera is turned on, the cam-
era will start panning and the position will automati-
cally be initialized.
• Do not touch the camera in the process of initializa-
tion. Otherwise, it may fail to initialize and may cause
malfunction.
• When the camera has been inadvertently touched
and moved after the initialization is complete, the pre-
set positions may be inaccurate. In this case, use the
position refresh function or restart the camera to cor-
rect the preset positions.
Refer to the Operating Instructions (PDF) for further
information.
Network connector
12 V DC power supply terminal
10BASE-T/
100BASE-TX
LINK
ACT
INITIAL
POWER
SET
12V IN
• Network connector
Connect a LAN cable (category 5 or better, STP*) to the
network connector.
* PAL model only
Important:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m {328'}.
• Make sure that the PoE device in use is compliant
with IEEE802.3af standard.
• When connecting both the 12 V DC power supply
and the PoE device for power supply, 12 V DC will be
used for power supply.
• When the LAN cable is disconnected once, reconnect
the cable after about 2 seconds. When the cable is
quickly reconnected, the power may not be supplied
from the PoE device.
EXT I/O
MIC/LINE IN
AUDIO OUT
MONITOR OUT
4 3 2 1