Diamond Audio MOTORSPORT MP525 Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Altavoces Diamond Audio MOTORSPORT MP525. Diamond Audio MOTORSPORT MP525 12 páginas. Pro audio horn coax drivers
Imprimir página
INSTALLATION
Installing the Speakers
Your new Diamond Audio MP series speakers were designed with the flexibility to be installed in
multiple Locations. However, to ensure the best performance possible, it is important to isolate the
front sound waves of the speaker from its rear sound waves. This is done by securely mounting the
speaker to a flat surface known as a baffle. Make sure to seal the speaker to ensure there are no
air leaks around its frame. Screws are included.
Selecting a Location
Since these are "Pro Drivers" we know the likelihood of mounting in stock locations is pretty non-
existent. This means basic audio concepts should be thought of when installing. Solid mounting, no
airleaks, etc. Venting (or porting) is not neccesary. Line the walls of the enclosures with deadliner
if possible.
We HIGHLY recommend that for the BEST sound you put a sound deadening mat on the door "skin",
fairing or bag, The more "damped" your vehicle/bike is.... the better it will ultimately sound!!!
Remember that the Midrange driver is 4 W and the Tweeter is 8 W . These drivers were especially
designed for Motorcycles but can be used in cars, trucks, boats and UTVs as the cones are UV
and water resistant. They are light weight and extremely efficient
SYSTEM DESIGN - PASSIVE
TYPICAL SYSTEM USING
INCLUDED PASSIVE CROSSOVERS
The DIAMOND AUDIO MP PRO AUDIO COAX
HORN drivers comes with a special 12dB per
octave crossover. It is HIGHLY recommended
that this be used at ALL times - UNLESS you
are using an active crosssover set at above 7kHz.
This system, shown is run off the Front channels
of this 4 channel amplifier are driving the MP65
Pro Audio CoAx Horn drivers. Rear channel are
driving the MP694 Pro Audio CoAx Horn drivers
(ONLY One Side - RIGHT- is shown)
(ONLY RIGHT CHANNEL SHOWN)
** SPECIAL NOTE**
Tweeter connected "Out-of-Phase" to be acoustically "In-Phase"
Front channels
A
U
D
I
O
Rear channels
MSCOAX tweeter
12dB per octave
High-Pass filter
(included)
+
"OPTIONAL"
TWEETER ATTENUATION
4 Channel
Amplifier
4 Ohm resistor
INCLUDED
+
5