Diamond Audio Technology D5 5.1 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Amplificador de coche Diamond Audio Technology D5 5.1. Diamond Audio Technology D5 5.1 17 páginas. Professional reference series amplifier

Imprimir página

In the most basic of terms, this means that car audio is gasoline powered. Extra

batteries are primarily for the extended operation of your audio system when

the engine is off, or for SPL competitions where high sound pressure levels are

generated for short periods of time. In which large battery racks are needed

to provide the necessary current demanded by the many amps used.

D5 Professional Reference Series Amplifiers are capable of reproducing

"concert level" volumes with incredible accuracy. Care must be taken to ensure

that your vehicle is capable of supplying the voltage and current required by

such a system.

POWER

CNTR -

FUSE

REM

30 AMP.

POWER (+12V)

Strip approximately 1/2 inch of insulation from the end of the power cable

going to the amplifier. Insert the stripped cable into the power block on the

end of the amplifier and tighten the Allen screw. Repeat for each amplifier

installed.

GROUND

For low power systems, locate a fairly thick metal area near the amplifier(s).

Inspect around and under the chosen area to make sure you won't drill into

wires, brake or fuel lines, computers, etc. Remove any paint and carpet glue to

a spot approximately 1 inch in diameter. Drill a hole into the middle of this

area. Cut a length of ground cable long enough to go from the ground point

to the amplifier. Terminate the ground cable with a ring connector and attach

it to the bare metal using a bolt, star washer and nut. Seal the area from above

and below to prevent rust. Strip approximately 1/2 inch of insulation from the

other end of the cable and insert it into the ground block on the amplifier and

tighten the Allen screw. For multiple amplifier systems, a ground distribution

block is recommended. Cut a length of cable long enough to go from the

ground distribution block to the amplifier. Strip approximately 1/2 inch of

insulation from each end of the ground cable. Insert one end into the ground

distribution block and tighten the Allen screw. Insert the other end of the

cable into the ground block on the amplifier and tighten the screw. Repeat for

each amplifier installed. Run a cable (the same gauge as the main power cable)

from the ground distribution block to the negative terminal of the system

battery.

Your D5 Professional Reference Series Amplifier is designed to accept up to 4

gauge power and ground cable.

5 Diamond Audio Technology