Aquatec PondMAX PX20000 Manual de instrucciones - Página 3
Navegue en línea o descargue pdf Manual de instrucciones para Bomba de agua Aquatec PondMAX PX20000. Aquatec PondMAX PX20000 8 páginas. High flow filtration pump
Imprimir página
BENEFITS
Suitable for filtration, water aeration and circulation, in bodies of water such as indoor and outdoor garden ponds;
medium to large aquariums, aquaculture, seafood markets and restaurants, as well as indoor and outdoor water
fountains. Suitable for both fresh and salt water.
• Your pump has a single moving part (an impeller set) enabling easy cleaning and maintenance.
• The Pumps have intelligent circuitry that analyses the speed and torque of the motor. It will increase and
the energy usage to maximise efficiency. The soft start nature of the system helps to avoid sudden pressure surges
causing pipes to blow off. The intelligent system will change the motor speed to maximise the flow of water in heat,
through lack of water flow through the motor.
• The motor and electrical components are totally encapsulated in epoxy resin, ensuring safe operation under water.
• The pump has a robust bearing and shaft design so no oil/grease lubrication is required.
• PondMAX Filtration & Waterfall Pumps are continuous rated therefore are designed to be heavy-duty and to
operate 24/7.
IMPORTANT SAFEGUARDS
Please read the operating instructions and familiarise yourself with the equipment before placing it
in service. Correct and safe use of the system requires strict compliance with the safety instructions.
For safety reasons persons less than 16 years of age or people that are not familiar with these
instructions should not use this equipment.
• Any damage to the equipment or unmerited operation
will bring dangers to the surrounding precincts. So if
there is any damage of the equipment, it must not to
be used. The equipment should be placed out of reach
of children.
• For your own safety, disconnect from the power supply
before any maintenance of any equipment is attempted
on the tank or water body. Always unplug the pump
from the power supply when not in use
• Never pull the cable to disconnect the plug from the
power supply - Grasp the plug and pull to disconnect.
• If required, have a qualified electrician install a
weatherproof power supply point near to the pond
or water-feature (within the cable length of the
appliance).
• Be sure the equipment is submerged completely in the
water. The depth should not be greater than 2m.
• Do not operate the pump if the appliance or any
components of the system, such as the power cable,
have been damaged. Check appliance for defects
regularly.
• Always use a properly grounded power supply that is
connected to an RCD with a rated residual operating
current not exceeding 30mA. As per AS/NZS
3350.2.41:1997
• To avoid an electric shock, do not attach the plug to the
power supply socket with wet hands. On installation,
the drip loop method should be used to prevent water
from traveling down the cable and onto the plug or
power supply. If the plug does get wet, do not unplug
PMAX PX20000_30000 Pumpss Instructions.indd 3
• Do not cut the cable as this will result in voiding your
• Do not install or store the appliance where it will be
• Care should be taken to arrange the power cable so
• Do not attempt to repair the electrical appliance
W A T E R G A R D E N I N G T O T H E M A X
HIGH FLOW
FILTRATION PUMP
the cable. Immediately disconnect the circuit breaker
that supplies power to the power supply point. Then
unplug and examine the plug, and power supply point,
for presence of water. If the power point has become
wet, you should consult an electrician before using the
power point again.
warranty.
exposed to extreme hot or cold temperatures. Do not
use in water above 35°C.
that it cannot be accidentally tripped over or pulled.
yourself. Return to an authorized service centre
or place of purchase if a fault occurs, (regular
maintenance is not considered repair and is required
by the user)
decrease
28/8/19 10:25 am