Diamond H2O DCF6-150-100 Manual de instalación, uso y mantenimiento - Página 6
Navegue en línea o descargue pdf Manual de instalación, uso y mantenimiento para Sistemas de filtración de agua Diamond H2O DCF6-150-100. Diamond H2O DCF6-150-100 18 páginas. Activated carbon water filter system
Imprimir página3.3.
ELECTRICAL
The Water Filter use requires single-phase 110 volt, 1 phase, 60 hertz, 5 amp service and is
equipped with a 10 foot electrical cord and a wall plug-in transformer.
NOTE:
We recommend that a licensed electrician install your system in accordance with
local and national electrical codes.
WARNING: To reduce the risk of electrical shock, the incoming power supply must include a
protective earth ground.
NOTE:
Some Filters are supplied with an optional micro-switch the closes during
Backwashing. The wires with connectors can be located coming out the back of the
control valve. These wires connect with the RO controller to prevent RO start-up.
4. GENERAL START-UP INSTRUCTIONS
1. Thoroughly read and comply with the instructions provided in this manual.
2. All plumbing connections to the system must be complete.
Note: Start up only one unit at a time and repeat these instructions for multiple units.
3. With the inlet and outlet isolation valves closed and the system bypass open; verify service
flow to the facility.
NORMAL OPERATION
Treated Water
Exists
4. Connect power to the unit.
5. Set control valve time and day. Refer to Control Valve Instructions or page 6 for
programming and set up.
N1022 Quality Drive
Supply Water
Enters
Diamond H2O
/
PO Box 170
Ph: (920) 757-5440 / (866) 757-9287 / Fax: (920) 757-5819
BYPASS OPERATION
Supply Water
Exits
/
Greenville, WI 54942
Supply Water
Enters
Page 4