HP 1810-8 Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Interruptor HP 1810-8. HP 1810-8 5 páginas. 8g switch

Mount the switch. (continued)

Wall Mounting: Install two 5/8-inch (15.875 mm) Number

12 wood screws, (included) into the mounting surface,

positioned 5.5 inches (140 mm) apart. Use the wall anchors

if necessary. Then, position the switch over the screws and

slide to lock in place.

Important: For wall-mounting, the network ports must be

facing up or down. Do not mount the switch with

ventilation holes facing up or down. (See "Installation

Precautions" on page 4.)

Under-Table Mounting: Install the two screws on the

table bottom similarly to the procedures for wall mounting.

Then, position the switch over the screws and slide to lock

in place. Install the third screw at the side of the switch to

prevent it from sliding out of the locked position, if

necessary.

. Power on the switch: Follow the same procedures as

in step 3.

It is recommended that you then secure the power cable

with the supplied cable tie.

Configure the switch for operation on your

network (minimal configuration).

Using a standard Ethernet cable, connect a PC directly to

any network port on the switch. Then configure the PC's

IP Address and Subnet Mask to allow it to communicate

with the switch through your PC's web browser.

Switch factory-default settings:

Parameter

Factory Default Setting

Password

<blank>

IP address

192.168.2.10

Subnet mask

255.255.255.0

Default gateway

not set

Modify the switch's IP configuration to operate in your network. See the example initial configuration page 3.

Note: When you are done with the initial switch configuration, disconnect the LAN cable from your PC and connect the

switch into the network.

Be sure to return your PC to its original network settings before connecting it to your network.

Connect to

any port