HP 1920 Gigabit Ethernet Switch Series Manual de introducción - Página 13
Navegue en línea o descargue pdf Manual de introducción para Interruptor HP 1920 Gigabit Ethernet Switch Series. HP 1920 Gigabit Ethernet Switch Series 33 páginas. Hp compaq presario,presario 1900: quick setup
También para HP 1920 Gigabit Ethernet Switch Series: Configuración rápida (2 páginas), Manual de introducción (10 páginas)
Imprimir página
Connecting cables
Connecting network cable
Use crossover cable or straight through cable to connect a PC or other network devices to the Ethernet
port of the switch.
Figure 12 Connecting network cable
Installing the SFP transceiver module and optical fibers
CAUTION:
Hold the SFP transceiver module by its two sides when you install or remove the module. Do not touch
•
the golden finger of the module.
•
Remove the optical fiber, if any, from a transceiver module before installing it.
To install an SFP transceiver module and optical fibers:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Pivot the clasp of the module up. Holding the module, gently push the module into the slot until it
has firm contact with the slot (when the top and bottom spring tabs catch in the slot).
3.
Remove protective sleeves from optical fibers, and the dust plug from the transceiver module.
4.
Connect the LC connectors of the optical fibers to the transceiver module.
NOTE:
Keep the protective sleeves for future use.
9