HP 316095-B21 - StorageWorks Edge Switch 2/24 Nota de publicación - Página 23

Navegue en línea o descargue pdf Nota de publicación para Interruptor HP 316095-B21 - StorageWorks Edge Switch 2/24. HP 316095-B21 - StorageWorks Edge Switch 2/24 23 páginas. Edge switch release notes
También para HP 316095-B21 - StorageWorks Edge Switch 2/24: Manual de actualización (9 páginas), Manual (41 páginas), Manual (40 páginas), Nota de publicación (32 páginas), Nota de publicación (27 páginas), Manual (26 páginas), Nota de publicación (27 páginas), Nota de publicación (25 páginas), Manual de instrucciones de instalación (24 páginas), Nota de publicación (23 páginas), Nota de publicación (22 páginas), Nota de publicación (23 páginas), Nota de publicación (19 páginas), Nota de publicación (19 páginas), Nota de publicación (18 páginas), Manual de instrucciones (17 páginas), Nota de publicación (17 páginas), Instrucciones de actualización (16 páginas), Manual de instrucciones (16 páginas), Manual de instrucciones de instalación (16 páginas), Nota de publicación (16 páginas), Nota de publicación (17 páginas), Nota de publicación (17 páginas), Nota de publicación (11 páginas)

Ports may accumulate spurious events

A port may accumulate Invalid transmission word and Bit-Error Threshold Link

Incident events when a transceiver is poorly seated, resulting in a poor ground

connection.

Workaround

Reseating the optical transceiver corrects the problem.

Possible switch reset after power failure or power off sequence

In extremely rare instances, after a power failure or power off sequence, an edge

switch or director configuration may be reset to factory default settings. This is

evident when HAFM is unable to communicate with the edge switch or director

after being powered on. This condition occurs because the IP address assigned to

the edge switch or director has been reset to the factory default value (10.1.1.10).

Workaround

If this condition occurs, the configuration of the edge switch or director must be

restored, and the IP address must be restored. Also, all licensed features need to be

reactivated by entering the license keys again.

Deleting a certain switch binding member using EWS may cause an error

An error 154 Invalid membership list occurs if you delete the last

member on the last page of the Switch Binding Membership List, and then you

delete the last member on the first page of the Switch Binding Membership List.

Workaround

Add additional members to the end of the list, and then you delete the intended

member.

SNMP issues

SNMP traps warmStart and coldStart are not always received across

Ethernet switches.

Workaround

None.

HP StorageWorks Edge Switch release notes

About this document