HP 5120-48G-PoE+ EI Manual de configuración - Página 35
Navegue en línea o descargue pdf Manual de configuración para Interruptor HP 5120-48G-PoE+ EI. HP 5120-48G-PoE+ EI 39 páginas. Hp 5120 ei switch series
También para HP 5120-48G-PoE+ EI: Ficha de datos (17 páginas)
Imprimir página
# Enable the spanning tree feature globally on the IRF fabric to prevent loops.
<DeviceA> system-view
[DeviceA] stp enable
# Connect the ARP MAD links as shown in
# Configure the IRF fabric to change its bridge MAC address as soon as the master leaves.
[DeviceA] undo irf mac-address persistent
# Create VLAN 3, and add port GigabitEthernet 1/0/1 (on Device A) and port GigabitEthernet
2/0/1 (on Device B) to VLAN 3.
[DeviceA] vlan 3
[DeviceA-vlan3] port gigabitethernet 1/0/1 gigabitethernet 2/0/1
[DeviceA-vlan3] quit
# Create VLAN-interface 3, assign it an IP address, and enable ARP MAD on the interface.
Because ARP MAD is not run between IRF domains, you can use the default value 0.
[DeviceA] interface vlan-interface 3
[DeviceA-Vlan-interface3] ip address 192.168.2.1 24
[DeviceA-Vlan-interface3] mad arp enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 0]:
The assigned
Configure Device C:
5.
# Enable the spanning tree feature globally on Device C to prevent loops.
<DeviceC> system-view
[DeviceC] stp enable
# Create VLAN 3, and add GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to VLAN 3.
[DeviceC] vlan 3
[DeviceC-vlan3] port gigabitethernet 1/0/1 gigabitethernet 1/0/2
[DeviceC-vlan3] quit
domain ID is: 0
31
Figure
13.