AQUATECH AxisGO Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Accesorios para teléfonos móviles AQUATECH AxisGO. AQUATECH AxisGO 6 páginas. Smartphone imaging system

Imprimir página

the back-plate edges, then point it down and

check the edges of the front port for any water

that may have penetrated. Water can enter the

AxisGO when opening the backplate, so do not

confuse this with a leak.

If this is all clear and there has been no ingress,

repeat Step 1 and hold the AxisGO under the

water for 30 seconds.

Repeat step 2, and if no water has entered you

are ready to install your iPhone and

begin shooting. If any water enters the

AxisGO during the test, dry it out completely

and then repeat the instructions on installing

your port and water testing. If a leak persists,

please email support at

Installing your iPhone

Make sure the inside of your AxisGO is completely

dry and clean. Clean the iPhone screen of any fin-

gerprints. Insert the iPhone into the rubber bumpers

inside the AxisGO. The home screen should face

upwards with the home button aligning with the

AxisGO home button.

Before closing the backplate, make sure the main

O-Ring is free from any sand or other debris. Close the

backplate and lock the side handle latch. Take care

that your leash does not interfere with the hinge or

O-Ring when closing the backplate.

Now your AxisGO is ready for the water, snow, dirt or

anywhere else you can take it!

Venting the AxisGO

'Venting' is the technique of expelling air from the

AxisGO before closing the backplate. To 'vent' your

AxisGO, apply pressure to the rear membrane as you

close the rear backplate and lock the side handle.

Pushing onto the phone with 1 finger (fig 3.) will

remove a small amount of air, or using your whole

palm will remove a greater amount of air. Each action

will have different pros and cons as sensitivity and

water interference* will vary through the techniques.

A unit that is not vented will be slightly less sensitive

[email protected]

when controlling the touchscreen and more resis-

tant to water interference. A fully vented unit will

be much easier to control and navigate the touch

screen, but will be more likely to receive water

interference. Experimenting with these techniques

will allow you to see which technique suits you and

your application best.

* Water interference is when turbulent water pushes

against the rear membrane and can activate the

screen unintentionally.

NOTE: It is recommended any screen protectors be

removed before using the AxisGO. The screen protectors

reduce touch sensitivity through the rear membrane

and can make controlling the phone difficult.

Using the AxisGO Underwater

Your iPhone uses a capacitive touch screen which

will not function the same underwater as it will

above. Functionality loss will occur to the touch-

screen when the AxisGO is used underwater.

Before going underwater make sure that your camera

app is open. You can use the volume buttons to fire

the camera, or start/stop video recording. When

staying below the surface for extended periods (ie:

diving) follow the below tips:

Set the phones 'Auto-Lock' to never.

Settings>Display & Brightness>Auto Lock

Turn 'Airplane Mode' on.

fig 3.