HP StorageWorks 1000 - Modular Smart Array Manual de inicio rápido - Página 6

Navegue en línea o descargue pdf Manual de inicio rápido para Interruptor HP StorageWorks 1000 - Modular Smart Array. HP StorageWorks 1000 - Modular Smart Array 7 páginas. Power supply, computer
También para HP StorageWorks 1000 - Modular Smart Array: Manual de la red (8 páginas), Lista de apoyo (34 páginas), Manual de prevención de errores (12 páginas), Libro Blanco técnico (12 páginas), Actualización del firmware (9 páginas), Visión general (20 páginas), Manual de instalación (2 páginas), Números de teléfono de asistencia (19 páginas), Manual de referencia (48 páginas), Manual de administración (40 páginas), Nota de publicación (13 páginas), Instrucciones de inicio rápido (8 páginas), Nota de publicación (5 páginas), Instrucciones de sustitución (4 páginas), Libro Blanco (13 páginas), Resumen tecnológico (15 páginas), Quickspecs (17 páginas), Especificación (49 páginas), Manual de introducción (34 páginas), Instalación (4 páginas), Manual de instalación (18 páginas), Manual de instrucciones de desmontaje (9 páginas), Manual de programación (8 páginas)

Conﬁguration procedures

Physically install and conﬁgure the disk array and the server as described below and in the manuals for

those products. Refer to the diagram under

Conﬁguration summary

You will perform the following tasks during conﬁguration:

•

Install Windows 2003 Server OS.

•

Install FC Host Bus Adapter and driver.

•

Connect the server HBA to the array using a FC switch and set up zoning (if required).

•

Install NIC card and connect to Ethernet LAN (optional).

•

Install HP MPIO software if multipathing is desired.

•

Connect the array to the VDS Server through the FC switch.

•

Verify existing or install MPIO software license.

Important conﬁguration notes:

Administrator privileges are required for all devices and software. If you do not have administrator

privileges, the software and hardware will not communicate properly.

When using the VDS framework to create and manage LUNs, the LUNs should be the same size as the

physical disk size. You can make LUNs smaller than a physical disk (or disks, if spanning multiple disks),

but any space left over on the physical disk(s) cannot be used. For example, if you have three 36

GB drives totalling 108 GB and you create a LUN of 20 GB spanning all three disks, the remaining

88 GB are unusable.

You may use Basic MPIO with the disk array and Provider server, but you will not be able to use VDS to

manage MPIO. Use whatever MPIO conﬁguration software you have available to manage MPIO.

You will perform the following tasks on the Windows server during installation:

•

Remove the previous version of the Provider, if necessary.

•

Run the Provider installation executable: setup.exe.

•

Follow the InstallShield Wizard instructions to install the software.

•

Install Microsoft QFEs (quick ﬁxes), if any. See the Provider README ﬁle for details.

•

Verify installation using Windows Disk Management and the DISKRAID List Provider command.

Conﬁguration and installation summary

Components

for an overview of interconnections.