HP StorageWorks 2/140 - Director Switch Nota de publicación - Página 24

Navegue en línea o descargue pdf Nota de publicación para Interruptor HP StorageWorks 2/140 - Director Switch. HP StorageWorks 2/140 - Director Switch 27 páginas. Director power cord advisory instruction
También para HP StorageWorks 2/140 - Director Switch: Nota de publicación (24 páginas), Manual de instrucciones de instalación (22 páginas), Nota de publicación (20 páginas), Nota de publicación (13 páginas), Nota de publicación (11 páginas), Nota de publicación (10 páginas), Instrucción (1 páginas)

NOTE:

This limit is disabled when the switch parameter Suppress Zoning RSCNs on Zone set

activations check box is enabled.

Known issues

This section describes the known issues related to the Director 2/64 and Director 2/140.

HSG80 transparent mode not supported with IBM AIX

Use of an HSG80 with IBM AIX is restricted to operating the HSG80 in Multibus mode

with the Director 2/64 and Director 2/140. Transparent mode is not supported at

this time.

Workaround

None.

HSG80 transparent mode not recommended with controller in SCSI-3 mode

with HP-UX operating systems

Due to an issue with nonexistent duplicate LUNs being displayed with the HP-UX

operating systems, the HSG80 controller is restricted to SCSI-2 mode of operation when

set to Transparent failover mode.

SCSI-3 mode of operation in Multibus failover mode is fully supported with the use of

Secure Path software, 3.0 or later versions.

Workaround

None.

ISL disconnect causes NOS error with the OpenVMS operating systems

When an ISL connection is physically removed between directors or switches, the Fibre

Channel Adapter model FCA2354 transmits a Not Operational Sequence (NOS)

error. This is observed as an entry in the HAFM appliance Link Incident log for the

port in which the FCA2354 is attached. The director's Hardware View also displays a

yellow triangle icon over the port that detected this incident. The fabric operation or

data movement is not disrupted by these incidents, and you can clear alerts from these

incidences using the following procedure.