HP StorageWorks 7110 - Virtual Array Instrucciones - Página 4

Navegue en línea o descargue pdf Instrucciones para Interruptor HP StorageWorks 7110 - Virtual Array. HP StorageWorks 7110 - Virtual Array 4 páginas. Private loop (hubs/direct connect)
También para HP StorageWorks 7110 - Virtual Array: Uso manual (34 páginas), Instrucciones de actualización (12 páginas), Manual (4 páginas), Manual (4 páginas), Instrucciones de instalación (2 páginas), Manual (2 páginas), Manual (1 páginas), Manual (1 páginas)

Imprimir página

HP StorageWorks 7110 - Virtual Array Instrucciones

11. Turn the deskside unit on end with the opening for the

disk drives facing up.

12. Install the end cap (Figure 6).

a. Insert the end cap into the tabs located at the top

front of the cover.

b. Rotate the end cap down over the base.

c. Using the T25 driver, install the remaining two M5

screws into the end cap and tighten the screws.

13. Rotate the cabinet to an upright position with the

front facing outward (Figure 7).

14. Position the unit on the floor in preparation for

installing the disk drives and power modules.

15. Using the Quick Start Guide, complete the array

installation.

a. Install the disk drives and power modules.

b. Cable up the array.

c. Turn it on.

d. Change the FC loop IDs.

e. Observe the power-on status.

Customer Order Part No.

A6196-90901

E0201

Figure 6

Figure 7

Manufacturing Part No.

A6196-96001

*A6196-96001*