HP XP20000/XP24000 Manual de configuración - Página 22

Navegue en línea o descargue pdf Manual de configuración para Interruptor HP XP20000/XP24000. HP XP20000/XP24000 42 páginas. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
También para HP XP20000/XP24000: Nota de publicación (13 páginas), Manual de integración (29 páginas), Nota de publicación (4 páginas), Manual del administrador (50 páginas), Manual de configuración (40 páginas), Manual de configuración (40 páginas), Manual de configuración (36 páginas), Manual de configuración (36 páginas), Manual de configuración (30 páginas), Manual de configuración (36 páginas), Nota de publicación (5 páginas), Manual de configuración (46 páginas), Manual de configuración (46 páginas), Manual de referencia (46 páginas), Manual de configuración (40 páginas), Manual de configuración (44 páginas), Manual de configuración (38 páginas), Manual de configuración (34 páginas), Manual de configuración (30 páginas), Manual de configuración (30 páginas)

Imprimir página
HP XP20000/XP24000 Manual de configuración

Adding the new device paths to the system

After configuring the FCAs and to ensure the new devices are recognized, some FCA drivers require
you to configure each LUN individually (either through the driver configuration file or in /kernel/
drv/sd.conf).
CAUTION:
To ensure that the system can boot properly even if you make a mistake in the driver configuration
file, add the new paths at the end of the file. (This ensures that the system boot entries higher up in
the file will execute first.)
Preconfigure additional LUNs (not yet made available) to avoid unnecessary reboots. Refer to
"Installing and configuring the

Verifying host recognition of disk array devices

Verify that the host recognizes the disk array devices as follows:
1.
Use format to display the device information.
2.
Check the list of disks to verify the host recognizes all disk array devices. If any devices are
missing or if no array devices are shown, check the following:
SAN (zoning configuration and cables)
Disk array path configuration (FCA HBA WWNs, host group 09 and host group mode 7 set,
and LUNs defined for the correct array ports)
Verify that host group 09 and host group mode 7 are set. Although host group mode 7 is
required only with the Sun SAN driver stack, always setting it is a best practice.
Host FCA configuration (WWN information, driver instance, target and LUN assignment,
and /var/adm/messages)
If you are using the Sun SAN driver and XP LUNs were not present when the configuration
was done, you may need to reset each FCA if no LUNs are visible. The following example
shows the commands to detect the FC-fabric attached FCAs (c3, c5) and resetting them.
# cfgadm -l | grep fc-fabric
c3
c5
# luxadm -e forcelip /dev/cfg/c3
# luxadm -e forcelip /dev/cfg/c5

Configuring disk array devices

Disk arrays are configured using the same procedure for configuring any new disk on the host. This
typically includes the following procedures:
1.
Labeling and partitioning the devices
2.
Creating the file systems
3.
Creating the mount directories
22
Installing and configuring Sun Solaris for the XP disk array
FCAs" on page 14 for individual driver requirements.
fc-fabric
connected
fc-fabric
connected
configured
unknown
configured
unknown