HP XP20000/XP24000 Manual de configuración - Página 27

Navegue en línea o descargue pdf Manual de configuración para Interruptor HP XP20000/XP24000. HP XP20000/XP24000 46 páginas. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
También para HP XP20000/XP24000: Nota de publicación (13 páginas), Manual de integración (29 páginas), Nota de publicación (4 páginas), Manual del administrador (50 páginas), Manual de configuración (42 páginas), Manual de configuración (40 páginas), Manual de configuración (40 páginas), Manual de configuración (36 páginas), Manual de configuración (36 páginas), Manual de configuración (30 páginas), Manual de configuración (36 páginas), Nota de publicación (5 páginas), Manual de configuración (46 páginas), Manual de referencia (46 páginas), Manual de configuración (40 páginas), Manual de configuración (44 páginas), Manual de configuración (38 páginas), Manual de configuración (34 páginas), Manual de configuración (30 páginas), Manual de configuración (30 páginas)

2 Troubleshooting

This section includes resolutions for various error conditions you may encounter.

If you are unable to resolve an error condition, ask your HP support representative for assistance.

Depending on your system configuration, you may be able to view error messages (R-SIMS) as follows:

In XP Remote Web Console (Status tab)

In P9000 or XP Command View Advanced Edition Software (Alerts window)

Table 4 Error conditions

Error condition

The logical devices are not recog-

nized by the host.

The host does not reboot properly

after hard shutdown.

Physical volumes cannot be created.

Logical volumes cannot be created.

A file system is not mounted after re-

booting.

The disk array performs a self reboot

because the disk array was busy or

it logged a panic message.

Recommended action

Verify the following:

The READY indicator lights on the disk array are ON.

Fiber cables are correctly installed and firmly connected.

The TIDs/WWNs on each bus are unique. Do not install two

devices with the same ID on the same bus. Recheck the buses for

new devices.

The maximum number of LUSE devices per port has not been ex-

ceeded.

The disk array host mode is set correctly.

If you power off the host without executing the shutdown process, wait

three minutes to allow the disk array's internal timeout process to purge

queued commands. If the host restarts while the disk array is processing

queued commands, the host may not reboot successfully.

Verify that the disk array logical devices are correctly formatted.

Verify that the volume capacity for OPEN-x volumes is not greater than

the maximum capacity allowed. See

emulations" on page 31.

Verify that the capacity of the volume group is not less than the total

capacity of the partitioned logical volume.

Verify that the host was restarted correctly.

Verify that the file system attributes are correct.

Reboot the host.

XP Disk Array Configuration Guide: Solaris

"Disk array device