aQuatell Fleck 5600SXT Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Dispensador de agua aQuatell Fleck 5600SXT. aQuatell Fleck 5600SXT 15 páginas.

With any water softener installation it is very important that all incoming and outgoing plumbing

is supported. The bypass should not support any of the weight of the plumbing as this will often

cause leaks or premature failure of the bypass. The plumbing can be supported by affixing it to a

wall. It is also important that incoming and outgoing plumbing is lined up properly with the

bypass. If plumbing is brought in on an angle, or if the plumbing exerts any sideward pressure

on the bypass valve, it will often cause a leak.

There are two bypass options for the Fleck valve as pictured below:

The plastic bypass comes in two pieces: the bypass and the plumbing adapter. The plumbing

adapter will be 3/4' or 1" threads as ordered. The first step in the installation of the plastic

bypass is to attach the bypass valve to the plumbing adapter. This is accomplished by pushing

the two pieces together and tightening the metal clips on the side (orange arrow above).

Both the plastic bypass/adapter and the stainless steel bypass are attached to the Fleck valve in

the same fashion:

Page 10

Fleck 5600SXT U.S. V1.1