aquatherm AT800 Manual de instalación - Página 2
Navegue en línea o descargue pdf Manual de instalación para Calentador de piscina aquatherm AT800. aquatherm AT800 16 páginas. Swimming pool & spa heat pumps
“black cabinet” with analog controls series only
También para aquatherm AT800: Manual operativo del propietario (12 páginas), Manual de instalación (8 páginas)
Imprimir páginaA. Introduction ............................................................................................
1. Unit Description
2. Explanation of Heat Pump Heat Transfer
3. Efficiency Comparisons
B. Unit Placement .........................................................................................
1. Placement Requirements
2. Air Flow Clearances & Service Access
3. Gutters, Overhangs & Sprinklers
C. Plumbing- Water Connections ................................................................
1. Basic Plumbing
2. Chlorinator & Chemical Feeder Requirements
3. Freezing Condition Plumbing Requirements
4. External Bypass Requirements Over 70 G.P.M.
5. Pool/Spa Combination Plumbing
6. Plumbing with Solar
7. Plumbing Above or Below Water Level
8. Optional Flow Switch Installation
D. Electrical Connections .............................................................................
1. Supply Wiring, Single Phase, 240V
2. Wire & Breaker Size Requirements
3. Bonding Requirements
4. 208 Supply Voltage Transformer Wiring Change
5. Factory Specification Chart
6. Wiring Diagrams - Single & 3 Phase
7. Interfacing with External Controls, Jandy & Compool
E. Control Panel Information & Operation & Description ...........................
1. Heater Controls
2. Indicator Light Explanations
3. Operation Sequence & Troubleshooting Flow Chart
Table of Contents
HEAT PUMPS
a Division of Calorex USA L.L.C.
2213 Andrea Lane Ft. Myers FL 33912
888-297-3826 941-482-0606
www.aquathermheatpumps.com
www.calorexusa.com
Written & Illustrated by Michael Glore
Page 3
Pages 4
Pages 5 - 7
Page 8 - 13
Page 14 - 15