Diamond Products CB515 Manual del usuario - Página 7
Navegue en línea o descargue pdf Manual del usuario para Taladro Diamond Products CB515. Diamond Products CB515 17 páginas. Diamond core drilling motor
Imprimir páginaSymbols used in this manual
V.............volts
A.............amperes
Hz............hertz
W............watt
~.............alternating current
n
...........no load speed
0
min
........revolutions or reciprocation
-1
per minute
......warning of general danger
....with electrical earth
DRILL SAFETY WARNINGS
•
Use auxiliary handles supplied with the tool. Loss of control can cause personal injury.
•
Hold power tool by insulated gripping surfaces, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and could give the operator an electric shock.
•
Never use the machine without the PRCD fault-current safety switch supplied.
•
Always check the PRCD fault-current safety switch for correct functioning before starting a drilling
operation.
•
Ensure that no water is allowed to get into the motor unit during operation.
•
If you detect a leak in any part of the water supply system, shut the machine down immediately
and repair the fault. Water pressure should not exceed 70 psi (4 bar).
•
Block off the working area and place warning signs on both sides of the wall when drilling through
from one side to the other.
•
Take appropriate precautions to ensure that, in the event of a drilling core dropping out, no
personal injury or material damage will result.
•
When drilling hollow components, check the flow route of the cooling water in order to prevent
damage.
INTRODUCTION
The machine is equipped with spirit levels which aid in aligning the tool. Use the Bull's Eye Level for vertical
aligning and the Tubular Level for horizontal aligning.
This machine is for the intended purpose of diamond core drilling of concrete, masonry, stone and similar
materials. The machine may be hand-held for drilling up to 80mm. For sizes above 80mm, it must be mounted
on a rig (drilling stand). The rig is not included.
All other uses which are not for the intended purpose are prohibited.
It is equipped with a water feed system which is required for the diamond core drilling process.
.......read these instructions
......always wear eye protection
......always wear a dust mask.
.....always wear hearing protection
.....wear safety-approved hard hat
do not dispose of electric tools,
accessories and packaging together
with household waste material
6