Diamond Products CSE12 Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Motosierra Diamond Products CSE12. Diamond Products CSE12 20 páginas. Electric chainsaw
También para Diamond Products CSE12: Lista de piezas y manual del operador (20 páginas)
Imprimir página
EQUIPMENT DESIGNATION OPERATOR'S MANUAL
Chain Saw Safety
•
Operate the equipment without using the
appropriate safety equipment required for
the work task.
•
Always hold the chain saw with your right
hand on the rear handle and your left hand
on the front handle. Holding the chain saw
with a reversed hand configuration
increases the risk of personal injury and
should never be done.
•
Hold the chain saw by insulated gripping
surfaces only, because the saw chain may
contact hidden wiring or its own cord. Saw
chains contacting a "live" wire may make
exposed metal parts of the chain saw "live"
and could give the operator an electric
shock.
•
Wear eye protection. Further protective
equipment for hearing, head, hands, legs
and feet is recommended. Adequate
protective equipment will reduce personal
injury from flying debris or accidental
contact with the saw chain.
•
Do not operate a chain saw in a tree, on a
ladder, from a rooftop, or any unstable
support. Operation of a chain saw in this
manner could result in serious personal
injury.
•
Always keep proper footing and operate
the chain saw only when standing on fixed,
secure and level surface. Slippery or
unstable surfaces may cause a loss of
balance or control of the chain saw.
•
Carry the chain saw by the front handle
with the chain saw switched off and away
from your body. When transporting or
storing the chain saw, always fit the guide
bar cover. Proper handling of the chain saw
will reduce the likelihood of accidental
contact with the moving saw chain.
•
Follow instructions for lubricating, chain
tensioning and changing the bar and chain.
•
Improperly tensioned or lubricated chain
may either break or increase the chance for
kickback.
•
Cut concrete, masonry, and similar
materials only. Do not use chain saw for
purposes not intended. For example: do
not use chain saw for cutting wood, metal,
or plastic materials. Use of the chain saw
for operations different than intended could
result in a hazardous situation.
Transporting Safety
•
Remove the blade prior to transporting the
equipment.
•
Make sure the truck/trailer is in good,
working condition and sufficient to transport
•
Raise the equipment to avoid damaging
components while moving up and down
ramps.
•
Use extreme caution when guiding
the equipment up and down
ramps. Slowly drive the equipment
forward down the ramp. Slowly
back the equipment in reverse up the ramp.
Avoid standing directly downhill from the
equipment to prevent machine rollover
•
Place the equipment in neutral and turn off
the engine once the equipment is loaded in
the truck/trailer.
•
Chock the wheels and secure the saw in the
truck/trailer prior to transporting.
•
Refer to the Department of Transportation
(DOT)
for
additional
recommendations.
•
DO NOT tow the equipment behind a
vehicle.
•
Close the fuel shutoff valve (applicable
models) when transporting.
•
Drain the fuel tank when transporting long
distances.
•
Use heavy-duty ramps that will support the
weight of the equipment and yourself when
loading or unloading.
Lifting Safety
•
Move yourself and all others away from
the lifting area when hoisting the saw to
prevent being crushed.
•
Secure the appropriate hoisting cables, straps,
and/or chains to the saw's designated lift points
prior to hoisting.
•
Never use the tie-down brackets (applicable
models) to lift the saw.
•
DO NOT attempt to lift the saw irresponsibly.
.
transportation
9