Panasonic P1SDU - SVGA LCD Projector Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Proyector Panasonic P1SDU - SVGA LCD Projector. Panasonic P1SDU - SVGA LCD Projector 42 páginas. Lcd projector commercial use
Imprimir página
Do not place any heavy objects on top of the projector.
B Failure to observe this may cause the projector to become unbalanced
and fall, which could result in damage or injury.
Do not short-circuit, heat or disassemble the batteries or place them
into water or fire.
B Failure to observe this may cause the batteries to overheat, leak, explode
or catch fire, and burns or other injury may result.
When inserting the batteries, make sure the polarities (+ and -) are
correct.
B If the batteries are inserted incorrectly, they may explode or leak, and fire, injury
or contamination of the battery compartment and surrounding area may result.
Use only the specified batteries.
B If incorrect batteries are used, they may explode or leak, and fire, injury or
contamination of the battery compartment and surrounding area may result.
Insulate the battery using tape or similar before disposal.
B If the battery comes into contact with metallic objects or other batteries, it
may catch fire or explode.
Do not put your weight on this projector.
B You could fall or the projector could break, and injury may result.
B Be especially careful not to let young children stand or sit on the projector.
If not using the projector for an extended period of time, disconnect the
power cord plug from the wall outlet.
B If dust builds up on the power cord plug, the resulting humidity may
damage the insulation, which could result in fire.
B This projector continues to draw approximately 3 W of power even when
the power is turned off.
Disconnect the power cord plug from the wall outlet as a safety
precaution before carrying out any cleaning.
B Electric shocks can result if this is not done.
If the lamp has broken, ventilate the room immediately. Do not touch or
bring your face close to the broken pieces.
B Failure to observe this may cause the user to absorb the gas which was
released when the lamp broke and which contains nearly the same
amount of mercury as fluorescent lamps, and the broken pieces may
cause injury.
B If you believe that you have absorbed the gas or that the gas has got into
your eyes or mouth, seek medical advice immediately.
B Ask your dealer to replace the lamp unit and check the inside of the
projector.
Ask an Authorized Service Center to clean inside the projector at least
once a year.
B If dust is left to build up inside the projector without being cleaned out, it
can result in fire or problems with operation.
8-E
NGLISH
B It is a good idea to clean the inside of the projector before the season for
humid weather arrives. Ask your nearest Authorized Service Center to
clean the projector when required. Please discuss with the Authorized
Service Center regarding cleaning costs.
We are constantly making efforts to preserve and maintain a clean
environment. Please take non repairable units back to your dealer or a
recycling company.
NOTICE:
B This product has a High Intensity Discharge (HID) lamp that contains a
small amount of mercury. It also contains lead in some components.
Disposal of these materials may be regulated in your community due to
environmental considerations. For disposal or recycling information
please contact your local authorities, or the Electronics Industries
Alliance: <http://www.eiae.org.>
Accessories
Check that all of the accessories shown below have been included with your
projector.
Card remote control unit
Lithium battery for
(N2QAYC000001 x1)
remote control unit
(CR-2025 x1)
POWER
INPUT
MENU
ENTER
AUTO
SETUP
STD
Power cord
SHUTTER
(K2CG3DR00005 x 1)
RETURN
VOLUME
ENTER
ROTATE
RGB signal cable
[1.8 m (5´10˝),
K1HA15DA0002 x1]
Softcase
(TPEP017 x 1)
E
-9
NGLISH