Panasonic PT-DZ12000 Instrucciones de uso
Navegue en línea o descargue pdf Instrucciones de uso para Proyector Panasonic PT-DZ12000. Panasonic PT-DZ12000 1 páginas. 3-chip dlp projector
También para Panasonic PT-DZ12000: Hoja de especificaciones (10 páginas), Hoja de especificaciones (10 páginas), Dimensiones (1 páginas), Manual de instalación y funcionamiento (37 páginas), Especificaciones (13 páginas)
Imprimir página
Additions and Corrections to the Operating Instructions
Installation in a downward vertical position
■
When installing the projector in a downward vertical position, please ensure to attach the supplied fi ttings to all lamp units.
Without the fi ttings, the lamp life may be shortened.
When installing the projector other than in a downward vertical position, remove the fi ttings.
1.
Range of the downward vertical position
Downward vertical position range:
45° forward and backward from the
position perpendicular to the ceiling.
2.
How to attach the fi tting to the lamp unit
Remove the lamp unit from the projector, following the "Procedure of lamp unit replacement" (Page 115) of
A
the Operating Instructions.
Insert the fi tting into the gap between the plastic holder and the wire mesh as shown in the fi gure below.
B
∗
Leave no gap between the fi tting and the wire mesh.
Install the lamp unit into the projector, following the "Procedure of lamp unit replacement" (Page 115) of
C
the Operating Instructions.
Changes in the table in page 21 of the Operating Instructions
■
Keystone correction only
Vertical
Keystone
Lens
Correction
Angle
α
ET-D75LE1
40
±
ET-D75LE2
40
±
ET-D75LE3
40
±
ET-D75LE4
40
±
ET-D75LE5
22
±
ET-D75LE6
28
±
ET-D75LE8
40
±
∗
For DZ12000, the above value changes apply.
PT-D12000/PT-DZ12000 Operating Instructions
When using arc and keystone correction together
Horizontal
Vertical
Keystone
Keystone
Correction
Correction
(°)
Angle
(°)
Angle
(°)
β
α
15
5
±
±
15
5
±
±
15
10
±
±
15
10
±
±
15
5
±
±
10
5
±
±
15
10
±
±
Insert fi tting between plastic
holder and wire mesh.
Horizontal
R2/L2
Keystone
minimum
minimum
Correction
value
Angle
(°)
β
5
1.6
±
5
1.2
±
10
0.8
±
15
0.6
±
5
3.0
±
5
2.4
±
15
0.4
±
Fitting
Plastic holder
Arc correction only
R3/L3
R2/L2
R3/L3 minimum value
minimum
value
value
D12000
3.2
0.8
2.4
0.6
1.6
0.4
1.0
0.3
6.0
1.5
3.0
4.8
1.2
2.4
0.8
0.2
DZ12000
1.6
1.2
0.8
0.5
∗
4.3
∗
2.6
0.4
P0908-0A